Typical Submersible Installation; Depth Of Installation - White S4A Installation And Operating Manual

TYPICAL SUBMERSIBLE INSTALLATION

Pump connected for
manual operation

DEPTH OF INSTALLATION

Make sure that the unit is at least one metre above any gravel layer and one metre below the minimum
drawdown level. If during the initial operation, the pump lowers the well water level until suction is
discontinued, then lower the pump where feasible, or install a protection device, or reduce the flow rate of the
pump to prevent over-pumping.
DAB Submersible Pump Installation Instructions 2013 rev 1
Submersible water pressure system
incorporating 100 litre pressure tank
3