Advertisement
Neckband
yy
PRESET
y yy
(M1~M15)
SENS
(DX/LOCAL)
VOL
Display
When the radio is not operated, the
display goes off.
A
Insert from the # side first.
yyy
yyy
yyy
yyy
C
yy
D
y y y
To a headphone jack (stereo mini-jack) of MD WALKMAN,
CD WALKMAN, etc.
AUDIO IN
yy
Earpad
yy
yy
AUDIO IN
RADIO ON/OFF•i
TUNE, +/–
B
yyyy
yyyy
yyy
Neckband
y y yy
1
3
2
Connecting cord
English
Getting Started
Battery
compartment
Installing the battery
lid
(See Fig. A)
Open the battery compartment lid on the
left earpad (marked L on the outside) and
insert one size AAA (R03) battery.
Be sure to position the battery according to
the polarity indicated in the compartment
and insert the battery from the # side first.
Battery life
Using Sony alkaline size AAA (LR03) battery:
Approx. 27 hours
Using Sony size AAA (R03) battery:
Approx. 11 hours
Replacing the battery
When the sound becomes weak or
distorted, replace battery with new one.
Alarm for Battery Exhaustion
When the battery becomes weak, an alarm
will beep, and "batt" will flash in the
display. Then, the power will be turned
off. When you turn on the power, you can
listen to the radio for a while, however, the
alarm will beep again. Make sure to
replace the battery with a new one.
Notes on batteries
• Align the battery correctly.
• The dry battery cannot be charged.
• To avoid damage from possible battery
leakage, remove the battery when the
unit will not be used for a long time.
If the battery compartment lid is
detached (See Fig. B)
If the compartment lid is opened forcibly,
the lid may become detached. If this
happens, reattach the lid as shown in the
figure.
Wearing the Radio(See Fig. C)
1
While positioning the left earpad
(marked L on the outside) on your left
side and the right earpad (marked R
on the outside) on your right side, wear
the neckband around the back of your
head.
2
Put your left ear between the earpad
(marked L on the outside) and the
neckband, and your right ear between
the earpad (marked R on the outside)
and the neckband.
3
Adjust the angle of the neckband to fit
the headphones on your ears.
Playing the Radio
– Manual Tuning
The display turns on only when the radio
is operated, so you can tune in a station
while seeing the display.
1
Set RADIO ON/OFF•i to ON.
2
Press TUNE +/– to tune in a station.
When + is pressed, the frequency is
raised. When – is pressed, the
frequency is lowered.
Each time + or – is pressed, the
frequency is changed in 0.1 MHz units.
To rapidly change the frequency, keep
pressing + or –.
3
Adjust VOL (volume).
To turn off the radio
Set RADIO ON/OFF•i to OFF i.
If noise is heard due to too strong
reception signal
Set SENS to LOCAL. Normally, set SENS to
DX.
Presetting Your Favorite
Stations
– Preset Tuning
You can preset up to 15 of your favorite
FM stations. To access the stations, simply
select the corresponding PRESET numbers
(M1 to M15).
Presetting a Station
1
Tune in a station to be preset manually.
2
Keep pressing PRESET (M1-M15) until
"M2" flashes and three beeps sound.
Example: When the 90.0 MHz station is
preset to "M2".
3
Press TUNE +/– to select the PRESET
(M1-M15) number.
4
Press PRESET (M1-M15).
You will hear beeps and presetting is
complete.
Changing the Preset Station
Follow from step 2 above to preset a new
station. The station previously stored to
the same preset number will be canceled.
Tuning in a Preset Station
1
Set RADIO ON/OFF•i to ON.
2
Press PRESET (M1-M15) so that the
desired preset number appears in the
display.
3
Adjust VOL (volume).
Listening to the sound of MD
WALKMAN, CD WALKMAN, etc.
(See Fig. D)
This unit can be used as a headphones.
Connecting the connecting cord (supplied)
to an portable audio equipment such as an
MD WALKMAN or CD WALKMAN
allows you to enjoy various sources via
this unit.
1
Set RADIO ON/OFF•i to OFF•i.
2
Connect the connecting cord (supplied)
to the AUDIO IN jack of this unit and
to the i (headphones) jack of an MD
WALKMAN, etc.
Connect the L shaped connecting cord
(supplied) to the jack of an MD
WALKMAN, and the other cord to this
unit.
3
Operate the MD WALKMAN, etc.
To adjust the volume, use the
volume control on the connected
equipment, such as an MD
WALKMAN, etc.
Notes
• To operate the radio while an audio
equipment is connected, turn off the
equipment and set RADIO ON/OFF•i
on this unit to ON.
• Refer to the operating instructions
supplied with the equipment to be
connected.
Advertisement
