Unpacking And Installation; Installation Procedure - Toshiba GA-1330 Service Manual

[3] UNPACKING AND INSTALLATION

1. Unpacking
2. Packaged goods

3. Installation procedure

This installation manual is provided for e-STUDIO203S/203SD
series.
For Installation to other models, see the operation manual of the
main unit or the service manual.
Turn off the main switch of the copier and remove the power
plug of the copier from the outlet.
(1) Cut the rear cabinet.
1) Remove the RADF from the main unit and gently place it on the
2) Cut out two cut-out portions from the rear cabinet using a cutter
3) Use a Phillips screwdriver or the like to open a hole.
4) Remove the screw and then remove the rear cabinet cover.
5) Cut out a part of the rear cabinet cover with nippers or the like as
(2) Attach the network expansion kit.
1) Engage the two pawls on the rear of the network expansion kit
2) Connect the connector of the network expansion kit to the con-
3) Secure the rear cabinet cover to the main unit with the screw.
4) Attach the RADF to the main unit.
GA-1330 UNPACKING AND INSTALLATION 3 - 1
document glass as shown in the illustration.
or the like.
shown in the illustration. (Be careful about the orientation of the
nippers so that the cross section is flat.)
with the cut-out portions of the main unit and secure the kit with
the supplied screw (3 x 14).
nector of the main unit.