Toro Groundsmaster 3500-D Service Manual page 111

Hydraulic Tank Removal
1. Drain hydraulic oil from Hydraulic tank (see Change
Hydraulic Fluid).
2. Remove hydraulic tank using Figure 41 as a guide.
Discard and replace any o--rings that are removed.
Hydraulic Tank Inspection (Fig. 41)
1. Clean hydraulic tank and suction strainer with sol-
vent.
2. Inspect hydraulic tank for leaks, cracks, or other
damage.
Groundsmaster 3500--D
Hydraulic Tank Installation
1. Apply anti--seize lubricant or equivalent to the two
flange head screws that secure the hydraulic tank.
Tighten the tank mounting screws from 30 to 60 in--lb
(3.4 to 6.8 N--m). Install tank using Figure 41 as a guide.
2. Thread suction strainer into hydraulic tank. Note:
Early models used a two piece suction strainer assem-
bly. On early models only, use hydraulic thread sealant
on threads of suction strainer and barb fittings during re-
assembly. Do not apply sealant to the first thread of the
fittings.
3. Using a wrench, turn strainer into tank port at least
1--1/2 to 2 full turns beyond finger tight.
4. Fill hydraulic tank with new hydraulic fluid (see
Change Hydraulic Fluid).
Page 4 - - 63 Hydraulic System (Rev. D)