Specifying Information About Your System - Meridian 501 User Manual

Specifying information about your system

In addition to configuring the sources, and programming their
levels, you can configure many other aspects of the operation of
the 501/501V Control Unit to suit the way your system is set up,
and the way in which you want to use it.
Note that any settings that you configure are reset to standard
values when you choose one of the standard settings: see
Choosing standard settings, page 20.
To configure the control unit
Turn off the control unit, using the power switch on the back
panel.
Turn on the power again while holding down the Display key
on the front panel.
The display will show:
It will then show the first
configuration option:
Press Copy to move between the options.
Press A or V to change the value of the current option.
30
The table below shows the options you can configure.
Option
Communications mode (500 or 200)
Controller mode (Auto, Con, or NCon)
System address (1–8)
Product address (1–8)
Volume control (Vout or Fout)
Volume mode (VolM or VolS)
Conf
Menu mode (N, 1, or 2)
5OO
Video version (501 or 501V)
200 Series CD player (N or Y)
Initial Value
5OO
Auto
SA=1
PA=1
Vout
VolM
≤≥N
5O1
CD?N