Cub Cadet 31BH57TU596 Operator's Manual page 8

Chute Assembly (If Equipped w/ Electric Chute Control)
1. Remove cotter pin, wing nut and hex screw from chute
control assembly. Remove clevis pin and bow-tie cotter pin
from chute support bracket. See Figure 3-3.
Chute Control
Assembly
Chute
Chute Base
2. Insert the round end of the chute control rod into the
chute control assembly. Push rod as far into chute control
assembly as possible, keeping the holes in the rod pointing
upward. See Figure 3-4.
8 S 3— A
ection SSembly
2
1
Chute Support
Bracket
Figure 3-3
Figure 3-4
& S -U
et p
3. Place chute onto chute base and ensure chute control rod
is positioned under the handle panel. Secure chute control
assembly to chute support bracket with clevis pin and
bow-tie cotter pin removed in step 1. See Figure 3-5.
1
4. Finish securing chute control assembly by installing hex
bolt and wing nut. See Figure 3-6.
5. Insert the other end of the chute control rod into the
coupler below the handle panel. Make sure to line up the
flat end of the rod and the flat end of the coupler. You may
need to rotate the rod around until these two surfaces line
up. See Figure 3-7 inset.
Figure 3-5
Figure 3-6