Panasonic HPX3000 Manual page 20

Table of Contents

Advertisement

PROXY Recording in ONE CLIP REC mode
PROXY recording is also possible in ONE CLIP REC
mode. As PROXY data is also similarly compiled into a
combined clip, the P2 viewer can also handle this data as
a single clip. However, note the following points when
recording PROXY data to a SD memory card.
If the SD memory card is removed and replaced while
combining to the clip, the PROXY is not recorded to the
next SD memory card until the clip stops being
combined. Check that there is sufficient space and also
the number of files (recordable up to a maximum of 1000
clips) before use. In the event that the SD memory card
is replaced while combining, continue recording the
PROXY by pressing and holding the STOP button for
about 2 seconds to stop combining and to start
recording to a new clip.
If the SD memory card is stopped while recording, the
PROXY data will not match the clip data recorded to the
P2 card and will be incomplete.
Precautions when in ONE CLIP REC mode
The INTERVAL REC and LOOP REC functions cannot
be used at the same time.
This mode does not operate when the REC SIGNAL
item is not set to "CAM".
The menu and thumbnail operations are restricted as
follows when combining to the clip. Press and hold the
STOP button for about 2 seconds to stop combining to
the clip when switching to this mode.
The following menu items cannot be changed.
SYSTEM MODE, REC SIGNAL, CAMERA MODE,
REC MODE, PC MODE, 25M REC CH SEL
The following Menu items, related to the reading/
writing of the SD memory card and reading of the
settings file, cannot be executed.
SD CARD READ/WRITE, LENS FILE CARD R/W,
READ USER DATA, READ FACTORY DATA,
Reading SCENE FILE, CAC FILE CARD READ
The following thumbnail menu items cannot be
selected and executed.
OPERATION > COPY
OPERATION > DEVICE SETUP > PROXY
The processing time to complete the recording may take
a little more time than normally to allow the clip to be
combined with subsequent recordings.
The fade process does not work on discontinuous audio
during playback where the recordings are combined
within the clip.
If non-linear editing software is used on clips with
multiple combined recordings, the software may not
operate normally (present as of Nov. 2009).
Refer to the P2 support page from the following web site
for the most recent information on software that has
been confirmed to work with these types of clips.
https://eww.pavc.panasonic.co.jp/pro-av/
Recording and Playback :ONE CLIP REC Function
41

Advertisement

Table of Contents
loading

Table of Contents