GMC 1986 P-Truck Service Manual page 383

4A-10 PROPELLER SHAFT
Install or Connect (Figure
Tools Required:
J-22610, Keystone Clamp Pliers.
J-25512, CV Propshaft Lube Gun (Ve-inch
pipe).
J-25512-2, Needle point.
• Lubricate the slip yoke (13) before installing
the boot (21). Refer to " Lubrication" later in
this section.
1. Boot (21) if used.
• Retainers (24) using J-22610.
. Slip yoke (13) to the axle yoke (
2
• Adjust propeller shaft (14) length.
• Mate the joint using reference marks.
— U-bolt, washer (
— Retainer (22) and bolt (20).
• Support the propeller shaft (14).
Figure 8 —Front Propeller Shaft and Driveline Detail
8 )
).
1 2
) and nut (10).
1 1
Front Axle Yoke
Slip Yoke
Propeller Shaft Assembly
U-bolt
Transfer Case
Flange
Bolt
Constant Velocity Joint
Bolt
Boot
Retainer
Front Axle Assembly
Washer
Clamp
a Tighten
• All fasteners to specified torque. Refer to
" Specifications" at the end of this section.
3. Bolt (18) at the flange (17).
• Mate the joint using reference marks.
• Lubricate the Constant Velocity Joint (19).
Refer to " Lubrication" later in this section.
4. Skid plate, if used.
a
Tighten
• All fasteners to specified torque. Refer to
"'Specifications" later in this section.
B-07561