Chain And Guide Bar Combinations - Echo CS-330T Instruction Manual

Bar
MoDeL
LengtH
12"
CS-330t 14"
16"
*Reduced nose radius symmetrical bars (OREGON name — Double Guard)
warning
Use of replacement saw chain and/or guide bar other than that specified, or operation without the "tip guard" in place,
may cause severe kickback resulting in serious injury.
Only use saw chain designated as, "LOW-KICKBACK," that meets CSA Z62.1, Z62.3 Standards when tested on
the representative sample of chain saws below 3.8 C.I.D., and the Echo guide bar specified.
iMPortant
Chain and guide bar gauge size must be identical. Use Bar/Chain combinations shown in table above.
iMPortant
If your kick guard is damaged or lost, contact your Echo dealer for a replacement. For the name of the
Echo dealer nearest you, Call: 1-800-432-ECHO (3246) or on the web at www.echo-usa.com.
refer to your Chain Saw Safety Manual for kick guard application information.
gUiDe Bar
(Low-kickback)
Replacement guide bars.
The following guide bars may be considered to
have equivalent kickback energy.
• Sprocket nose guide bars of the same length and
nose radius, same pitch and having the same
number of teeth.
• Hard nose guide bars of the same length and
nose radius as a sprocket nose bar.
c g
HAIn AnD
the following combinations may be used on CS-330t.
Low KiCKBaCK
gUarD Bar
Bar P/n CHain Part no.
12A0ED3745 91PX-45 91VG-45
14A0ED3752 91PX-52 91VG-52
16A0ED3757 91PX-57 91VG-57
B c
UIDe AR omBInAtIons
Low KiCKBaCK Saw CHain
LinKS
45
52
57
SAW CHAIN
(Low-kickback)
Do not use replacement saw chain unless
it has been designated as meeting the
CSa Z62.1, Z62.3 kickback performance
requirements.
note
LOW KICKBACK SAW CHAIN meets the
kickback performance requirements of CSA
Z62.1, Z62.3(safety requirements for gasoline-
powered chain saws).
21
tYPe gaUge
PitCH
91PX
3/8" 0.050
91VG
CAUTION
KiCK
gUarD
eCHo P/n
(oeM P/n)
2894901
28949