Table of Contents
Advertisement
IMPORTANT! The battery must be removed from your vehicle for
the initial charge in order to complete assembly. After assembly
is complete, you do not need to remove the battery from your
vehicle to recharge it.
Charger
Connector
1
• Plug the battery connector into the charger connector.
Power Indicator
2
• Plug the charger into a standard wall outlet.
Notes:
- The power indicator on the charger does not indicate the
charge status of your battery. The power indicator allows you
to see that there is power from the wall outlet.
- If power flow to the wall outlet is controlled by a switch, make
sure the switch is "ON".
- Use the charger only in a wall outlet. Do not plug the charger
in to a ceiling outlet.
• Before first time use, charge the battery for at least 18 hours.
Never charge the battery longer than 30 hours.
• Recharge the battery after each use of your vehicle for at least
14 hours. Do not charge the battery longer than 30 hours.
• Once the battery is charged, disconnect the charger connector
from the battery connector. Unplug the charger from the
wall outlet. The battery is now ready to be installed in your
vehicle. Please see "Battery Installation" on page 11 for
detailed instructions on installing your battery. If your battery is
already installed in your vehicle, simply re-connect the battery
connector and motor connector and replace the battery retainer.
M1350pr-0920
BATTERY CHARGING
Battery
Connector
• Locate the battery compartment on the bottom of the sounds and
• Loosen the screw in the battery compartment door.
• Insert one "AA" (LR6) alkaline battery into the battery compartment.
• Replace the battery compartment door and tighten the screw.
Hint: We recommend using an alkaline battery for longer battery life.
Battery Safety Information
In exceptional circumstances, batteries may leak fluids that
can cause a chemical burn injury or ruin your product. To avoid
battery leakage:
• Do not mix old and new batteries or batteries of different
• Insert batteries as indicated inside the battery compartment.
• Remove batteries during long periods of non-use. Always remove
• Never short-circuit the battery terminals.
• Use only batteries of the same or equivalent type,
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the product before charging.
• If removable, rechargeable batteries are used, they are only to be
1.5V x 1
"AA" (LR6)
lights box.
Protect the environment by not disposing of this product with
household waste (2002/96/EC). Check your local authority for
recycling advice and facilities (Europe only).
types: alkaline, standard (carbon-zinc) or rechargeable
(nickel-cadmium).
exhausted batteries from the product. Dispose of batteries safely.
Do not dispose of this product in a fire. The batteries inside may
explode or leak.
as recommended.
charged under adult supervision.
M1350pr-0920
Advertisement
Table of Contents
