Toshiba 50L1450U User Manual page 7

Integrated high definition led television
Hide thumbs Also See for 50L1450U:
Table of Contents

Advertisement

7
Removing the Pedestal Stand
1 ) Carefully lay the front of the unit face down on a flat,
cushioned surface such as a quilt or blanket. Leave
the stand protruding over the edge of the surface.
Note: Extreme care should always be used when
removing the pedestal stand to avoid damage to
the LCD panel.
2) Remove the stand screws shown in the diagram
below.This will allow removal of the pedestal stand,
3) Once you have removed the screws holding the
pedestal stand in place, remove the pedestal stand
from the TV,
50" TV.
VESA Mounting Pattern
Hook Sturdy strap
Four stand screws
(as short as possible)
(Sample Illustration)
CAUTION: Always place the TV on a sturdy, level,
stable surface that can support the weight of the unit.
To secure the TV, use a sturdy strap from the hook(s)
on the rear of the TV to a wall stud, pillar, or other
immovable structure. Make sure the strap is tight,
secure, and parallel to the floor.
FCCDeclaration of Conformity
ComplianceStatement (Part 15):
Toshiba 50L1450U
Television models comply with
Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device nmst accept any interference received,
including imerference that may canse tmdesired operation.
The part?,: responsible for compliance to these roles is:
Toshiba America Information Systems, Inc.
9740 Irvine Blvd., Irvine, CA 92618.
Ph: 800-631-3811
Note: This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable
protection
against
harmful interference
in a residential
installation.
This
equipment generates,
uses, and can radiate radio
frequency
energy and, if not installed and used in
accordance
with the instructions, may cause harmful
interference
to radio communications.
Howeve_ there
is no guarantee
that interference
will not occur in a
particular
installation.
If this equipment
does cause
harmful interference
to radio or television reception,
which can be determined
by removing and applying
power to the equipment,
the user is encouraged
to try
to correct the interference
by one of the following
measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and
receiver.
Connect the eqnipment into an outlet on a circuit different
from that to which the receiver is connected.
Consuh the dealer or an experienced radioiTV technician
for help.
"Caution: Changes or modifications
to this equipment
not expressly approved by Toshiba could void the
user's authority to operate this equipment.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents