Table of Contents
Advertisement
MAINTENANC
ELECTRICAL
forgas leaks a fter r econnection.
(See ANTI-TIP BRACKET
Installation instructions for gas leak
To prevent range from aecidently tip-
CONNECTION
test
m ethod.)
Appliances which require electrical
ping, range should be secured to the
power are equipped with a three-prong
floor by sliding rear leveling leg into an
grounding plug which must be plugged
NOTE: A qualified servicer should dis-
anti-tip bracket supplied with the range.
directly into a properly grounded three-
connect and reconnect the gas supply.
hole 120 volt electricaloutlet.
To prevent range from accidently tip-
PROPORTIONAL
VALVE
ping, range must be secured to the floor
by sliding rear leveling leg into an anti-
ADJUSTMENT
(if equipped)
_(_ _"
tip bracket supplied with the range.
The LOW setting should produce a sta-
_
ble flame whenturning the knobfrom HI
_
WARNING: Possible risks may result
to LOW.The flame should be 1/8 inch or
from abnormal usage, including exces-
lower and must be stable on all ports on
"
sive loading of the oven door and of the
LOW setting.
risk of tip over, should the appliance not
,
_
be reinstalled according to the installa- To adjust: Operate burner on HI for
A/ways disconnect power to appli,
tion instructions,
about 5 minutes to preheat burner cap.
Turn knob back to LOW; remove knob,
ance before servicing,
and insert a small screwdriver into the
LIGHT
REPLACEMENT
center of the valve stem. Adjust flame
If an ungrounded, two-hole or other
Before replacing oven light bulb, DiS-
size by turning adjustment screw in
type electrical outlet is encountered, IT
CONNECT POWER TO RANGE. Be
either direction. Flame must be of suffi-
ISTHE PERSONALRESPONSIBILITY
sure bulb and range parts are cool. Do
cient size to be stable on all burner
OF THE APPLIANCE OWNER TO
not toucha hot buibwith adampcloth as
ports. If flame adjustmentis needed, ad-
HAVE
RECEPTACLE
REPLACED
the bulb may break,
just ONLY on the LOW setting. Never
WITH A PROPERLY GROUNDED
adjust flame sizeon a higher setting.
THREE HOLE ELECTRICAL OUTLET. To replace oven light: Use a dry pot
Thethree-prong grounding piugis pro-
holder, to prevent possible harm to
vided for protectionagainst shock haz-
hands; very carefully remove bulb. Re-
..<_
_.._4_...
ards. DO NOT CUT OR REMOVE THE
place with a 40 watt APPLIANCE bulb,
-_.__"
_ _-"_'m-_.
THIRD GROUNDING PRONG FROM
Reconnect power tothe range.
THE POWER CORD PLUG.
__
HOW TO REMOVE
LEVELING LEGS
Some floors are not level. For proper
RANGE FOR CLEANING
baking,your range mustbe level. Level-
AND SERVICING
ing legs are located on each corner of
_,
the base ofthe range, Placea level hori-
Follow these procedures to remove ap-
zontally on an oven rack and check
pliance for cleaning or servicing:
front-to-back and side-to-side. Level
by turning the legs.
1. Shut-off gas supply to appliance.
NOTE: All gas adjustments should be
done by a qualified servicer only.
2. Disconnect electrical supply to ap-
pliance, if equipped.
3. Disconnect gas supply tubing to ap-
pliance.
4. Slide range forward to disengage
_
range from the anti-tip bracket. (See
InstaffationInstructionsfor locationof
bracket.)
-_
5. Reverse procedure to reinstall. If gas
_,_
line has been disconnected, check
-15-
Advertisement
Table of Contents
