Memorex MP3227 User Manual page 12

CASSETTE OPERATION (CONTINUED)
MAKING A TAPE RECORDING
The tape recorder in this system allows you to make direct recordings from the radio or CD player to a blank
cassette in the tape compartment. An automatic recording volume level control (ALC) circuit will automatically
control the volume level of your recordings to prevent distortion. You may change the settings of the volume
or the Bass Boost during a tape recording, as these controls have no effect on the material being recorded
onto the tape.
To make a tape recording, proceed as follows:
1
Open Surface Side
Full Reel on Right
Open the Cassette Door and
insert a good quality blank
cassette tape into the slots on the
door, with the open end facing up
and the full reel on the right side.
Close the Cassette Door.
4
To avoid recording unwanted
material, such as
commercials, use the PAUSE (p)
button to stop the recording
temporarily. Release the PAUSE
(p) button to begin recording
again.
2
1
Press the POWER button 1 to the
in position and slide the Function
switch 2 to select the function
you wish to record, either CD, AM
or FM, and operate that function
according to its own instructions.
5
When you are finished recording,
radio press the STOP/EJECT (I )
button to stop the tape.
3
2
When you are ready to begin
recording, press the RECORD (Q)
button. The PLAY (¦) button will
also engage. The tape will begin
moving and all of the material from
your selected source will be
recorded on the tape.
6
If you wish to listen to your
recording immediately, press the
cassette REWIND (‹‹) button
1 until the tape rewinds to the
beginning,
STOP/EJECT (I) button 2. Slide
the Function switch 3 to the
TAPE/POWER OFF position,
then press the PLAY (¦) button
4 to begin playback.
11
3
2
4
then press the