Controlling The Temperature; Basic Temperature Of Freezer And Fridge Compartments; Controlling The Freezer Temperature; Reverse Osmosis Water Supply - Samsung SRF890SWLS User Manual

Removing any residual matter inside
the water supply line after installing
the water filter.
1. Turn ON the main water supply and supply
water from water supply line.
2. Run water through
the dispenser until
the water runs clear
(approx. 6 to 7
minutes). This will
clean the water supply
system and remove air
from the lines.
3. Additional flushing may be required in some
households.
4. Open the Refrigerator door and make sure
there are no water leaks coming from the
water filter.
Be sure to flush the dispenser thoroughly,
otherwise water may drip from the
dispenser.
This means that there is still air in the line.

Reverse Osmosis Water Supply

IMPORTANT:
The pressure of the water supply coming out of a
reverse osmosis system going to the water inlet
valve of the refrigerator needs to be between 35
and 120 psi (241 and 827 kPa).
If a reverse osmosis water filtration system is
connected to your cold water supply, the water
pressure to the reverse osmosis system needs to
be a minimum of 40 to 60 psi (276 to 414 kPa.)
If the water pressure to the reverse osmosis
system is less than 40 to 60 psi (276 to 414 kPa):
• Check to see whether the sediment filter in the
reverse osmosis system is blocked. Replace
the filter if necessary.
• A llow the storage tank on the reverse osmosis
system to refill after heavy usage.
• I f your refrigerator has a water filter, it may
further reduce the water pressure when used
in conjunction with a reverse osmosis system.
Remove the water filter.
If you have questions about your water pressure,
call a licensed, qualified plumber.
DA68-02915A-11.indd 34
CONTROLLING THE
TEMPERATURE
Basic temperature of Freezer and
fridge compartments
The basic and recommended temperatures of the
Freezer and Fridge compartments are -19 °C and
3 °C respectively.
If the temperature of the Freezer and Fridge
compartments are too high or low, adjust the
temperature manually.
Controlling the Freezer
temperature
RF31FMES**(For sparkling water model only)
Recommend Temp (Freezer) : -19°C
RF31FMED**(For Ice/Water model Only )
Recommend Temp (Freezer) : -19°C
The Freezer temperature can be set between
-23°C and -15°C to suit your particular needs.
Press the Freezer button repeatedly until the
desired temperature is shown in the temperature
display. The temperature will change by 1°C (or
1°F) with each press. See below.
Centigrade : -19°C ➞ -20°C ➞ -21°C ➞ -22°C
➞ -23°C ➞ -15°C ➞ -16°C ➞ -17°C ➞ -18°C ➞
-19°C.
Keep in mind that foods like some ice cream may
melt at -15.5°C. The temperature display will
move sequentially from -23°C to -15°C.
English - 34
2015. 5. 8. 8:52