17” LCD MONITOR Please read the user’ s manual carefully before using the monitor FOR YOUR SAFETY---------------------------------------------- User's Manual SAFETY PRECAUTIONS -------------------------------------- SPECIAL NOTES ON LCD MONITORS -------------------------- BEFORE YOU OPERATE THE MONITOR ---------------------------- FEATURES -------------------------------------------------- PACKING LIST --------------------------------------------- OPERATING INSTRUCTIONS -------------------------------------- GENERAL INSTRUCTIONS ------------------------------------ HOW TO ADJUST A SETTING---------------------------------- ADJUSTING THE PICTURE -----------------------------------...
Page 2
Before operating the monitor please read this manual thoroughly. This manunl should be retained for future reference. FCC Class B Radio Frequency Interference Statement WARNING:(FOR FCC CERTIFIED MODELS) NOTE:This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
SPECIAL NOTES ON LCD MONITORS The following symptoms are normal with LCD monitor and do not indicate a problem. NOTES ?? Due to the nature of the fluorescent light, the screen may flicker during initial use. Turn off the Power Switch and then turn it on again to make sure the flicker disappears. Or you can use of AUTO function.
FRONT PANEL CONTROL ?? Power Key: Press this button to switch ON/OFF of monitor's power. ?? MENU/Enter: Activates the OSD menu or function adjust confirm . ?? Contrast: Adjust contrast or function adjust. ?? Brightness: Adjust brightness or function adjust. ?? Auto Adjust Key/Exit: When OSD menu is in off status, press this button direct to activate the Auto Adjustment function.
2.6 Exit 3. Function 3.1Auto Adjust Reset to original factory geometry setting 3.2Auto Colour Reset to original factory color setting 3.3Exit Adjust the picture Focus. 4. OSD Menu 4.1 Language Muti-Language selection. Chinese / English / French / German / Italian / Spanish / Japan 4.2 OSD H.
When there is no video input signal this monitor, following a time-out period, will automatically switch to an OFF mode. This reduces the monitor's internal power supply consumption. After the video input signal is restored, full power is restored and the display is automatically redrawn.
ERROR MESSAGE AND POSSIBLE SOLUTION CABLE NOT CONNECTED : 1.Check that the signal-cable is properly connected , If the connector is loose, tighten the connector’s screws. 2.Check the signal-cable’s connection pins for damage. INPUT NOT SUPPORT: Your computer has been set to unsuitable display mode, Set the computer to display mode given in the following table.
?? Auto Adjust Key/Exit ?? Brightness ?? Contrast Switch ?? Power Key ?? MENU/Enter ?? Brightness External Controls: ?? Geometry ?? Color ?? Language Functions ?? Auto Adjust ?? Exit ?? Recall ON Mode <48W(For 4 CCFL) EPA ENERGY STAR OFF Mode <5W Regulatory...