Limited (WRR), listed on the Australian Stock Exchange, is a world leader in design, manufacture and distribution of specialised communications equipment for the Inmarsat Satellite Network. BEAM’s commitment to be at the forefront has continued to increase its share of the global satellite communications market. Its premium distribution BEAM Communications Pty Ltd network spans the world.
All wireless phones may get interference, which Global Positioning System could affect performance. GSPS Inmarsat’s Global Satellite Phone Service PABX Private Analogue Branch Exchange Record Header Write details of your unit for easy reference when required. Ideal when troubleshooting. IsatDock2 MARINE - User Manual...
Package Contents Optional Accessories Additional Information Check that your IsatDock2 MARINE package The following optional accessories are available For the latest in supporting software and contains all of the following items: for your IsatDock MARNIE documentation for IsatDock please go to www.beamcommunications.com/support/...
Safety Extra Low » areas where fuel odors are present (for The IsatDock2 MARINE is a low power docking Voltage (SELV) requirements of IEC60950. example, if a gas/propane leak occurs in a station for the IsatPhone 2 handset. When ON, car or home);...
When it is ON, it receives and » International Commission on Non-Ionizing also sends out radio frequency (RF) signals. Radiation Protection (ICNIRP) 1996 (NOTE: Refer to Inmarsat IsatPhone 2 Manual » Verband Deutscher Elektrotechniker WARNING for additional Information)
IsatDock FCC Information This equipment has been tested and found This device has been designed to operate with to comply with the limits for a Class B digital antennas ISD710 AT1595-82, ISD715/ISD720 devices, pursuant to Part 15 of the FCC AT1595-83 and having a maximum gain of 6dBi.
Should ALWAYS keep the phone more than six inches from their pacemaker when phone is turned ON. • Should turn the phone OFF immediately if you have any reason to suspect interference is taking place. IsatDock2 MARINE - User Manual...
The Personal Alert button is located on the front enabled, the loop will be armed and activated Commands of the IsatDock2 MARINE. A single button press with an open-loop condition, triggering on alert on the dock will send an instant GPS position on the IsatPhone 2.
An audible ‘click’ is heard when the phone is in the docked position. IMPORTANT: Before docking the IsatPhone 2 to the docking station, check that the USB/Audio adapter has been connected to the IsatPhone 2. IsatDock2 MARINE - User Manual...
This guide outlines the process for installing • Route cables so they are protected from electrical radio system operation. The the IsatDock2 MARINE in conjunction with an pinching, sharp edges, and crushing. ignition system is the most common Inmarsat IsatPhone 2 handset and antenna.
Installation Procedure 1) BEAM Antenna Connection Anntena Connection Diagram Installing the IsatDock2 MARINE To connect the IsatDock2 MARINE to the GSPS Cradle BEAM Antenna, requires the use of certified Install the components in the following order. satellite and GPS antenna cables. These cables...
Page 18
DO NOT pull with force on the cables from the rear docking station is mounted securely. of the IsatDock2 MARINE. Please install strain relief clamping for the antenna cables where required. Correct installation of the antenna system is a vital...
Page 19
2b) Desk Mounting Orientation The Security Bolt Security bolt ensures the MARINE docking unit is The IsatDock2 MARINE supports a desk firmly fixed to the wall and prevents the docking mount configuration. Depending on the users station from sliding back up freeing the dock.
Page 20
(1) Springless Cup for Normal light-use Desk mounted cradle position. The Privacy Handset is conveniently mounted on to the IsatDock2 MARINE enclosure, The ‘springless’ cup is fitted to the docking station providing a local handset function. with the mounting clip in a ‘flush’ position.
Page 21
4) Access to Rear Connector Bay (2) Spring Cup - Heavy duty use cup In harsh environments, the Privacy handset is For the IsatDock2 MARINE, the external cable actively retained in the mounting cup. This is interfaces are at the rear of the docking station.
Page 22
Telephone Service) Telephone is supported by for longer runs (up to 45 meters). This loop can the IsatDock2 MARINE. It supplies power to the support multiple buttons / switches – wired in USB Data Port analogue phone as well as ring, dial and busy tones.
Page 23
If a call is in progress while this as the vessel key is enabled or disabled. If occurs, the IsatDock2 MARINE will stay on for 20 this function is not required, the YELLOW minutes after the call is terminated. Please follow wire MUST be connected to the RED wire.
Page 24
• Rear Cover Screwed in Place. The rear cover Right angled adapters can be fitted to the The IsatDock2 MARINE has an ingress Protection of the MARINE dock must be screwed down antenna connectors to allow routing of cables rating of 54. When installing the IsatDock it is with at least the four screws indicated below through a wall.
IsatDock2 MARINE Usage MARINE Cover The IsatDock2 MARINE docking station achieves Operation of the IsatPhone 2 an IP54 rating over the handset by the use of a NOTE: hinged cover . The cover is released by the latch Prepare the Inmarsat IsatPhone 2 (1) If the IsatPhone 2 is removed from the dock at the base of the cover.
Bluetooth® calls via IsatPhone 2 its cup. This automatically directs the call audio Once the call is connected, the STATUS LED The IsatDock2 MARINE allows for Bluetooth to the privacy handset. will flash to indicate a call is in progress.
During a call, Press the Mute button on the Once the call is connected, the STATUS LED front of the IsatDock2 MARINE, a RED LED will flash to indicate a call is in progress. will illuminate the Mute button to confirm Press the RED key on the IsatPhone 2 that the uplink audio is muted.
Personal Alert & Assistance Alert Operations IMPORTANT order to send a tracking message, the following Please refer to the Inmarsat IsatPhone 2 User If the BEAM Alert Loop is going to be used conditions must be fulfilled for a docked...
Answer inbound call in speakerphone mode * This action is optional, only when the Personal Alert Mode for your IsatPhone 2 is configured. A beep will only sound if audible alerts are enabled in the Falcon IsatDock2 MARINE - User Manual...
IsatDock2 MARINE Buttons/LED lights MUTE BUTTON GREEN YELLOW WHITE/OFF Outgoing audio is Outgoing audio is ILLUMINATED muted not muted POTS/RJ11 in use FLASHING GREEN YELLOW WHITE/OFF STATUS LED Handset registed and Handset not ILLUMINATED able to make a call registered/no signal...
This problem is more evident when result in degraded performance and may damage wind and smoke. numerous antennas and broadcasting devices the IsatDock2 MARINE. This will void the product are located within close proximity to each other. warranty. Symptoms of RF interference...
Speakerphone In-built speaker/microphone 2x IsatDock2 Adapters Peak Current 3.5A Certifications 110-240V AC Plug Pack Inmarsat Type Approval, FCC, CE Compliance, Electrical Safety, Metric Physical Specifications Imperial Privacy Handset RoHS, Industry Canada, C-Tick, EMC Compliance Dimensions 270 x 189 x 101 10.6 x 7.4 x 4...
RED) network. The IsatPhone 2 will also indicate obstructions. Check the signal strength on the handset. “Inmarsat” in the top left corner of the BEAM certified antenna cabling is being Ensure the Headset connector at the base screen display.