Check Inlet And Drain Led's Flash Together; Digital Display Shows - Miele W1113 Technical Information

Technical Information
3.2 Check Inlet And Check Drain LEDs Flash Together
Symptom
In normal operation mode on models with a digital display 3 dashes
are displayed. The water intake valves are closed and the program
is interrupted. The Drain Pump is activated for 120 seconds.
Cause
The Float Switch in the bottom of the appliance has switched; a
leak has been registered by the Electronic unit.
Remedy
Shut off the water supply.
Remove water from drip tray
Perform necessary service.
3.3 Digital Display Shows: – – –
Symptom
During operation the digital display shows 3 dashes. The Water
Intake Valves are closed and the program shuts down. The Drain
Pump is activated for 120 seconds.
Cause
The Electronics contain a registered a fault.
Remedy
Access the Service Mode and check for stored fault(s).
If either Electronic was recently replaced, ensure the correct
part number is installed and the appliance is programmed
correctly.
Check the electrical connection between the control/power
module panel/Display Electronic.
W1113, W1119, W1203, W1213 & W1215 Clothes Washers
40