Britax Advocate 70 CS User Manual page 20

Rear-Facing Installation
1 Loosen the harness.
a Lift harness adjuster lever
b Pull both harness straps forward
2 Remove the body pillow,
unbuckle the harness, and
remove the belly pad.
3 Pull the head restraint cover up,
then pull the seat cover forward
while pulling the buckle through to
access the rear-facing belt path.
Open both lock-offs (blue).
4
a Pull the locking tab up
b Pull the clamp down
5 Route the vehicle belt through the
rear-facing belt slots, then buckle.
Do NOT pre-tension the top
(shoulder) part of the vehicle belt.
TIP: Ensure the vehicle belt is not twisted.
Remove excess slack from the bottom
(lap) part of the vehicle belt before
closing the lock-offs.
Ensure that both parts of the
6
vehicle belt are routed through
each lock-off, then close the
lock-offs.
a Push the clamp up
b Push the locking tab down until
locked
7 Push the child seat into the vehicle
seat while pulling the top (shoulder)
part of the belt between the lock-
offs (pull away from the buckle) to
remove slack.
TIP: The shoulder part of the vehicle belt
must be on top when removing slack.
36
b
a
b
a
LOCKING
TAB
CLAMP
5
7
8 Pull slack through the lock-off
toward the vehicle belt retractor.
9 Rear-facing installations can be
improved by the use of the Versa-
Tether (see page 26 – 29).
10 Replace the cover and belly pad.
Check that the
child seat is
reclined to position 3
Check buckle
connection
Checklist
9 Check that the vehicle belt is securely fastened.
9 Check that the child seat cannot be moved front to back or side to side more
than 1 in. (2.5 cm) at the belt path. If the child seat is not secure, repeat
installation and ensure all slack is removed from the vehicle belt or use a
different seating location.
9 Check that the back angle of the child seat is 30º – 45º from vertical (not to
exceed 45º) when the car is parked on a level surface.
* If necessary, the proper recline angle can be achieved by placing a
rolled towel or pool noodle in the vehicle seat bight.
Rear-Facing Installation
8
Check that there is
LESS than 1 in. (2.5 cm)
of movement (front to back or
side to side) at the belt path
37