GE GSD2800 Series Use And Care Manual page 5

DOOR LATCH "OFF" POSITION
Soil Options
CHINA RINSE HEAVY NORMAL
CRYSTAL & HOLO SOIL
SOIL
00000 0,0 @m
Select a Soil Option
If you wish to make program
changes, start with the soil level.
Y should select a change within
OU
30 seconds, otherwise all panel
lights will go out. To relight, touch
any pad or open and re-close door.
HEAVY SOIL should be
selected when dishes are extra
soiled or extra greasy. This gives
dishes an extra rinse in every cycle
except RINSE & HOLD. This
lengthens cycle.
NORMAL SOIL is automatically
programmed when a cycle is
selected. You may want to change
the selection depending on the soil
on your dishes.
. LIGHT SOIL will save time and
money if you pre-rinse your
dishes. This shortens all cycles
except RINSE & HOLD.
Heating Options
LIGHT
SOIL RINSE
STEP 5
Select a drying option
HEATED DRY on—Provides
faster drying. Can be changed
while cycle is running.
HEATED DRY off (Energy
Saver)—Shuts off heating unit.
Dishes air-dry naturally. It takes
longer, but saves energy. You can
prop door open about 3 inches
after motor stops to speed drying.
Excellent for overnight drying.
Energy Saver helps reduce
electrical energy used by this
model approximately 6~o.
HEATED RINSE—Select with
either POTSCRUBBER or
NORMAL WASH. Heats water in
final rinse to 140°F.–1450F. Touch
pad once for on, once more for off.
This option may be changed at any
time before or after start of cycle.
When selected, the cycle may
extend up to 20 minutes while the
machine heats the water. During
the heating extension the minutes
countdown is on hold.
STEP 6
Start the dishwasher
When you're ready to wash
dishes, touch the START pad.
There is a time delay between
start-up and water fill so you
will not hear any wash action
right away. Dishwasher will
proceed through your entire
program and turn off automatically.
To delay the start, touch DELAY
START pad. The SYSTEMS
MONITOR will read "1 hrs delay."
Touch pad once again for each
hour desired up to 9 hours. The
machine will count down and start
automatically at the correct time.
Note: Don't forget to put detergent
in cup and close cup. Do not use
DELAY START with the RINSE &
HOLD cycle.
To change a cycle after washing
starts, touch the CLEAR RESET
pad to cancel cycle. After water
is pumped out and motor stops,
you can reprogram and restart
the dishwasher.
5