Drill Master 68420 Owner's Manual & Safety Instructions page 6

Operating Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section
at the beginning of this manual including all text under
subheadings therein before set up or use of this product.
1. Place the Battery Pack on a dry
fireproof surface in a room where the
temperature is from 50–104° F.
Note: If recharging a newly spent Battery Pack,
allow it to cool completely before charging.
2. Examine the Battery Pack.
It must be undamaged, and an
18V, NiCd or NiMH type Battery Pack.
Do not charge a cracked, open, or
leaking Battery Pack, or charge a
non-recommended type of Battery Pack.
3. The Battery Pack's terminals are
designed to fit this Charger specifically.
If the Battery Pack does to not fit the Charger
properly, do not try to insert it. Do not
force a Battery Pack into the Charger.
4. Plug the Power Supply into a grounded,
120VAC, 60Hz receptacle.
5. Connect the Power Supply to the Charger.
6. Slide the Battery Pack onto the Charger.
Page 6
For technical questions, please call 1-888-866-5797.
Note: The Battery Pack's capacity will increase
somewhat during the first few charging
cycles. A fully discharged Battery Pack will
take about 3-5 hours to fully charge.
7. While charging, the Battery Pack,
Charger, and Power Supply may become
warm to the touch. This is normal,
and does not indicate a problem.
8. The red LED will light continuously when
the Battery Pack is charging. The green
LED will light when the battery is charged.
Unplug the Charger and disconnect it
from the Battery Pack when finished.
CAUTION! The Battery Charger needs
to be disconnected when charging is
finished to prevent overcharging.
9. Allow the Battery Pack to cool
completely before using it.
10. Press the Battery Button to release
Battery Pack from the Charger.
Item 68420