Meade 70AZ-AR Instruction Manual page 5

Tel70AZAR_5 3/28/07 10:09 AM
ASSEMBLE YOUR TRIPOD
The tripod is the basic support for your
telescope. Its height may be adjusted so that
you can view comfortably.
N N o o t t e e : : N N u u m m b b e e r r i i n n b b r r a a c c k k e e t t s s , , e e . . g g . . , , ( ( 3 3 ) ) , , r r e e f f e e r r
t t o o F F i i g g . . 1 1 . .
1. Make sure that as you attach the legs (7)
to the mount that the leg braces (9) are
facing inward.
2. Line up the holes at the top of one of the
legs with the holes in the mount (10).
See Fig. 2.
3. Thread one of the 2-inch bolts through
the holes.
4. Thread a wingnut over the bolt and hand-
tighten to a firm feel.
5. Attach the remaining two legs to the
mount in the same manner.
6. Spread the legs out evenly apart.
7. Set the height of your tripod:
a. Rotate and loosen the leg lock
thumbscrew (20) to unlock the leg lock.
b. Slide the inner portion of the leg (19) in
or out to the desired length. Repeat for
the other two legs.
c. Rotate and tighten the leg lock
Looking at or near the Sun will cause irreversible damage to your eye. Do not point this telescope at or near the Sun. Do not look through the telescope as it is moving.
Page 5
Fig. 2
2" Screw
thumbscrew to relock the leg lock.
d. Repeat for the other two legs.
ATTACH THE ACCESSORY TRAY
The tray helps stabilize the tripod and is also
a convenient holder of eyepieces and other
Meade accessories, such as the Barlow lens.
1. Line up the holes at the end of one of the
leg brace supports (8) with the holes in
one of the leg braces (9).
2. Thread one of the one-half inch bolts
through the holes.
3. Thread a hex nut over the end of the bolt.
4. Finger tighten the bolt and hex nut.
See Fig. 3.
5. Repeat with the two other
mount
leg braces.
6. Thread the accessory tray (26)
over the center mounting bolt to
a firm feel.
ATTACH THE OPTICAL TUBE TO THE MOUNT
The optical tube gathers distant light which
is focused in the eyepiece.
1. Remove the two lock knobs (5) from the
tripod
washer
optical tube mount.
leg
wingnut
2. Slide the altitude rod (17) into the hole in
the altitude adjustment control . Tighten
to a firm feel. See
3. Place the optical tube (4) between the
forks of the mount, oriented as shown
in
Fig. 4.
Fig. 4.
finger tighten the
hex nut
3
Fig. 3