Time Setting - Digipulse MW-300C Instruction Manual

measurements the monitor will push the previous measurement
back one space. In other words, the value in space one will always
be the most recent blood pressure measurement taken. Your
monitor will store up to 60 measurements. To review measurements
in the memory, press the " " button. Press the " " button in
M M
succession to review all 60 of your last blood pressure
measurements.

Time setting

Your monitor will keep track of the time unless the batteries have run
down or are removed from the monitor. To set the time, turn on your
monitor, press the " " button，the hour will begin to flash. Press the
" "button until the correct hour appears on the display. Press the
M
" "button, the minute will begin to flash. The minute set up process
is the same as the hour. Then press the" "button to store the time .
After that you can measure your blood pressure, or press the
20