Gigabyte G1.Sniper H6 User Manual page 64

Step 3:
After entering the CREATE VOLUME MENU screen, enter a volume name with 1~16 letters (letters cannot
be special characters) under the Name item and press <Enter>. Then, select a RAID level (Figure 11). RAID
levels supported include RAID 0, RAID 1, Recovery, RAID 10, and RAID 5 (the selections available depend on
the number of the hard drives being installed). Press <Enter> to proceed.
Intel(R) Rapid Storage Technology - Option ROM - 13.0.0.2075
[hi]-Change
Step 4:
Under Disks item, select the hard drives to be included in the RAID array. If only two hard drives are installed,
they will be automatically assigned to the array. Set the stripe block size (Figure 12) if necessary. The stripe block
size can be set from 4 KB to 128 KB. Once you have selected the stripe block size, press <Enter>.
Intel(R) Rapid Storage Technology - Option ROM - 13.0.0.2075
[hi]-Change
Configuring SATA Hard Drive(s)
Copyright (C) Intel Corporation. All Rights Reserved.
[ CREATE VOLUME MENU ]
Name : Volume0
RAID Level : RAID0(Stripe)
Disks : Select Disks
Strip Size : 16KB
Capacity : 931.5 GB
Sync : N/A
Create Volume
[ HELP ]
RAID 0: Stripes data (performance).
[TAB]-Next [ESC]-Previous Menu
Figure 11
Copyright (C) Intel Corporation. All Rights Reserved.
[ CREATE VOLUME MENU ]
Name : Volume0
RAID Level : RAID0(Stripe)
Disks : Select Disks
Strip Size : 16KB
Capacity : 931.5 GB
Sync : N/A
Create Volume
[ HELP ]
The following are typical values:
RAID0 - 128KB
RAID10 - 64KB
RAID5 - 64KB
[TAB]-Next [ESC]-Previous Menu
Figure 12
- 64 -
[ENTER]-Select
[ENTER]-Select