Advertisement
CAUTION
Be careful when bringing the piano into an upright
position. There is an enormous risk to overbalance
the unit when not handled properly, which may
result in damage to the instrument, personal
property or even cause serious injury. Make sure
that a minimum of two persons are involved in
accomplishing the next step and follow the
instructions carefully.
NOTICE
Make sure that the pedal screw underneath the
pedal board is screwed tightly and will not stick
out too far. Otherwise the pedal board might be
damaged when taking the next step.
7) Hold the unit at the top and lift it towards the legs, bringing
the piano to an upright position.
Be absolutely sure to hold the piano at the positions
shown in fig. 5 to minimize the risk of overbalancing.
Fig. 5: Setting the piano upright
8) Connect the pedal cable to the pedal connector which can
be found on the connector board on the underside of the
console.
9) Attach the headphone hanger
the console's underside, underneath the keyboard and close
to the front.
Fig. 6: Attaching the headphone hanger
EG540 ASSEMBLY
10) Adjust the pedal screw underneath the pedal board until the
screw firmly touches the ground.
1) Lift the music rest.
2) Pull the two hinges located at the back of the music rest to a
position of about 20° and slowly push the rest to the console's
back until the hinges secure the position.
with two screws (S4) to
For parquet or laminate floor, you may consider
using felt underlays to protect the floor and ensure
a non-slippery surface.
Fig. 7: Adjusting the pedal screw
Using the music rest
Fig. 8 : Lifting the music rest
3
Advertisement
