Specifications Of The Starblast 6/6I; Specifications Of The Intelliscope System - Orion STARBLAST 6/6I Manual

10. Specifications of the
StarBlast 6/6i
Primary mirror diameter: 150mm
Primary mirror:
Secondary mirror
minor axis:
Focal length:
Focal Ratio:
Mirror Coatings:
Focuser:
Eyepieces:
Magnification:
Finder:
Weight:
Tube Length:
Parabolic
47.0mm
750mm
f/5.0
Aluminum with SiO2 overcoat
Rack-and-pinion, accepts 1.25"
eyepieces
25mm and 10mm Sirius Plössl,
1.25"
30x (with 25mm eyepiece), 75x
(with 10mm eyepiece)
EZ Finder II reflex sight
23 lbs., 8 oz.
28 inches
11. Specifications of the
IntelliScope System
Objects in database:
• 110 Messier (M) objects
• 7840 New General Catalog (NGC) objects
• 5386 Index Catalog (IC) objects
• 8 Major planets
• 99 User-defined objects
Computer interface:
Power:
This device complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) this device may
not cause harmful interference, and (2) this device must
accept any interference received, including interference that
may cause undesired operation.
Changes of modifications not expressly approved by the party
responsible for compliance could void the user's authority to
operate the equipment.
Note: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a resi-
dential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interfer-
ence to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or televi-
sion reception, which can be determined by turning the equip-
ment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an output on a circuit different
from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician
for help.
• A shielded cable must be used when connecting a
peripheral to the serial ports.
RS-232 port
Requires one 9V battery
27