Use; Control Panel - Smeg SHB450X Instruction Manual

USE

Button Function
Turns the lighting system on and off at maximum
A
intensity.
Turns the lighting system on and off in Courtesy Light
mode.
Turns the Motor off.
B
Press and hold for approximately 5 seconds to Lock /
Unlock the Keyboard, for example in order to clean the
surface.
Turns the Motor on at Speed one.
C
Turns the Motor on at Speed two.
D
Turns the Motor on at Speed three.
E
Activates/Deactivates intensive speed from any other
F
speed, including motor off. This speed is set to operate
for 10 minutes, after which the system returns to the
speed that was set before. Suitable to deal with
maximum levels of cooking fumes. Can also be
deactivated by pressing button B.
Press and hold the button for approximately 5 seconds,
with all the loads turned off (Motor and Lights), to turn
the Activated Charcoal Filter alarm on/off.
24H function
G
Turns the motor On/Off at speed one and allows
recirculation for 10 minutes every hour. It cannot be
activated if the Intensive or Delay functions are in use.
When the filters alarm is triggered, the alarm can be
reset by pressing and holding this button for
approximately 5 seconds.
These indications are only visible when the motor is
turned off.
Delay function
H
Activates/Deactivates automatic switch-off with a 30'
delay. Suitable to complete elimination of residual
odours. Can be activated from any position. It cannot
be activated if the Intensive or 24H functions are in
use.
Press and hold the button for approximately 5 seconds,
with all the loads turned off (Motor and Lights), to turn
the Remote control on/off.
Remote control receiver.
R
EN

Control panel

Led
On/Off
On/Off
The buttons turn light up one at a time in cycle.
On/Off
On/Off
On/Off
Flashes once a second.
Button B (Flashes twice)-Alarm Activated.
Button B (Flashes once)-Alarm Deactivated.
On/Off
B flashes three times.
When the procedure terminates, the indication shown
previously turns off:
Button G flashes, indicating the need to wash the metal
grease filters. The alarm is triggered after the Hood has
been in operation for 100 working hours.
Button G flashes, indicating the need to change the
activated charcoal filters, and also to wash the metal grease
filters. The alarm is triggered after the Hood has been in
operation for 200 working hours.
On/Off
Button B (Flashes twice)-Remote control Activated.
Button B (Flashes once)-Remote control Deactivated.
8 8