GE TFX24E Use And Care Manual page 8

Electronic Monitor & Diagnostic System
(continued)
The Electronic Monitor and
Diagnostic System
alerts you when
something starts to go wrong.
If a diagnostic code appears on
the display, something needs
special attention.
To get your
attention, the display code flashes
until you erase it. The first 6
flashes are accompanied by beeps.
If more than one coded function
requires attention at the same
time,
the one with the highest
priority will be displayed first.
Pressing the SYSTEM CHECK- .
RESET-pad will evaluate all other
coded functions. If the NORMAL
display is lit during the displaying
of a code, that function is operating
properly.
Pressing the SYSTEM CHECK-
RESET pad will erase three codes
immediately-~~ Cl and CC.
The DE
and FFcodes can only be
erased by touching the SYSTEM
CHECK-RESET pad
after
the
condition that caused the code to
flash has been corrected.
This flashing code tells you the
power to the refrigerator has
been interrupted for more than 2
seconds. Check ~hecondition of
food in both the fresh food and
freezer compartments. Touch
SYSTEM CHECK-RESET pad
to erase code.
This flashing code tells you
something's wrong with the defrost
system—keep doors closed to
retain cold and call for service.
Code flashes until problem is
corrected.
There is no fault with the
refrigerator when
PF
code
flashes.
,,.
This flashing code tells you to
check your frozen fired. Has any
of it started to thaw? A package
may be holding the freezer
compartment door open. Don't
open the door more often than
absolutely necessary while this
code is displayed. Touching the
SYSTEM CHECK-RESET pad
after the freezer compartment
temperature has returned to
normal will erase the code.
This flashing code tells
YOU to
check the automatic icemaker.
Ice clumps in the storage bin may
have stalled the icemaker. Follow
corrective measures described on
page 20. If water supply to the
icemaker is not connected or not
turned on, make sure manual
icemaker switch is in the OFF
position (see page 10). Code stops
flashing when problem is corrected
or SYSTEM CHECK-RESET pad
is touched.
This flashing code tells you to
check temperature controls and
adjust them if necessary. (See
directions on page 5.) Touch
SYSTEM CHECK-RESET pad
to erase code. If code reappears
after 4 hours, call for sefiice.
,,. ,
'-d
8
—- -—.. ....<-.— . .*— .. . . . — ..—. ... ..—-. — .—
..-—- --- . ... . ..... .. - . --- ..----.—-... ~—.. —. . .. . .. —----- ----