Inserting Batteries Into The Remote Control - Cisco CIS2000 Quick Reference Manual

Inserting Batteries into the Remote Control

Two batteries are needed for the remote control (Type AAA 1.5 V, included)
Insert the batteries into the remote control as follows:
1. From the back of the remote control, push
the tab down and pull the battery cover
away from the device.
2. Insert the batteries in a single row into the
compartment. Pay attention to the polarity
of the batteries. The correct position is
indicated inside the battery compartment.
3. Insert the battery cover (edge opposite tab)
and push it toward the remote control until
the tab locks into place.
T13402
9