Install Moisture Barrier (On Some Models) - Maytag W10199707A Installation Instructions Manual

Option B, No waste disposer – no air gap
No waste disposer – no air gap
Waste tee Waste tee Waste tee
Drain trap Drain trap
1. Connect black end of of drain hose to
1
Black end
waste tee and cut if needed.
(Do not cut ribbed section.)
2. Attach black end of drain hose to waste
2 tee with a large silver drain hose clamp
(provided). Use pliers to squeeze clamp
open and move into position. If the drain
hose was cut, use a 1 1/2" to 2" (3.8 to
5 cm) screw-type clamp (not provided).
Option C, Waste disposer – with air gap
Waste disposer – with air gap
Screw-type clamps Screw-type clamps Screw-type clamps
Disposer inlet Disposer inlet
1. Using a hammer and screwdriver,
1
knock plug into disposer.
2. Use needle nose pliers to remove
2
plug.
3. Connect black end of drain hose to air
3
Black end
gap and cut if needed. (Do not cut
ribbed section.)
4. Attach drain hose to air gap with large
4
silver drain hose clamp (provided).
Use pliers to squeeze clamp open and
move into position. If the drain hose
was cut, use a 1 1/2" to 2" (3.8 to
5 cm) screw-type clamp (not
5
provided).
5. Use a rubber hose (not provided) with
screw-type clamps (not provided) to
connect from air gap to disposer inlet.
10
Screw-type Large silver
drain hose clamp clamp
Drain hose
Air gap Air gap
Large silver drain Large silver drain
hose clamp hose clamp
(provided)
Rubber hose
connector
Drain hose
Drain trap
Option D, No waste disposer – with air gap
No waste disposer – with air gap
Screw-type clamps Screw-type clamps Screw-type clamps
Waste tee Waste tee
Drain trap Drain trap
1. Connect black end of drain hose to air
1
Black end
gap and cut if needed. (Do not cut
ribbed section.)
2. Attach drain hose to air gap with large
silver drain hose clamp (provided).
2
Use pliers to squeeze clamp open and
move into position. If the drain hose
was cut, use a 1 1/2" to 2" (3.8 to 5 cm)
screw-type clamp (not provided).
3
3. Use a rubber hose (not provided) with
screw-type clamps (not provided) to
connect from waste tee to air gap.
Install moisture barrier
(on some models)
Install moisture barrier
(on some models)
Moisture
1. Make sure the area under the cabinet is clean and dry
for installation of the moisture barrier.
2. Remove the backing of the moisture barrier and apply
to underside of the countertop along the front edge of
the counter.
Air gap Air gap
Large silver drain Large silver drain
hose clamp hose clamp
(provided)
Rubber hose
connector
Drain hose
barrier