Adjustable Rollers; Base Grille; Clearances; Location - GE Side by Side 22 Dispenser Use And Care Manual

Refrigerator Location
Do not install refrigerator where temperature will
be below 60°F. because it will not run often enough
to maintain proper temperatures.
Do install it on a floor strong enough to support it
Also see Energy-Saving Tips regarding location.
Rollers
Adjustable roller behind the base grille enable you to
move the refrigerator away from the wall for cleaning.
These rollers should be set so the refrigerator rests
firmly on the floor. To assure that the doors will close
automatically from a halfway-open position, there is a
built-in tilt from the front to the back of the cabinet.
Side-by-side refrigerators also have specially designed
door hinges that lift both doors slightly when opened,
allowing the force of gravity to help close them securely.
To adjust rollers,
remove the base grille by
grasping it at the bottom
and pulling it out.

Water Supply to Icemaker

You will need to connect your icemaker to a cold
water line. A water supply kit containing copper
tubing, shut-off valve, fittings and instructions is
available at extra cost from your dealer. There should
be sufficient tubing from the cold water supply to the
icemaker inlet to allow you to move the refrigerator
out from the wall several feet (approximately 8 feet of
1/4" copper tubing in three 10" diameter coils).
Do
not use kits with plastic tubing, since there
is water pressure in the supply line at all times.
Preparing for Vacation
For shorter vacations, remove perishable foods and
leave controls at regular settings. However, if room
temperature is expected to drop below 60°F., follow
instructions as in the Temperature Controls section.

Clearances

Allow the following clearances for ease of
installation, proper air circulation and plumbing
and electrical connections:
Top . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1"
Back . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1"
If refrigerator is against a wall on either side, allow
3/4" for door clearance.
clockwise to raise refrigerator,
counterclockwise to lower it.
Use adjustable wrench (3/8" hex
head bolt) or pliers.
When adjusting front rollers for
proper door closure, we recommend that the bottom
front edge of the cabinet be approximately 5/8" from
the floor.
To replace base grille,
align prongs on back
of grille with clamps in
cabinet and push back
until the grille snaps
into place.
Preparing to Move
Disconnect power cord from wall outlet, remove all
food, and clean and dry the interior.
Secure all loose items such as grille, shelves and
storage pans, by taping them securely in place to
prevent damage.
Be sure refrigerator stays in upright position" during
actual moving and in van. Refrigerator must be
secured in van to prevent movement. Protect the
outside of the refrigerator with a blanket.
For extended vacations or absences, remove food
and shut off power to the refrigerator. Clean the interior
with baking soda solution of one tablespoon of soda to
one quart of water. Wipe dry. To prevent odors, leave
open box of soda in refrigerator. Leave doors open.
Move the icemaker feeler arm to the STOP (up) position
and be sure to shut off the water supply to the refrigerator.