Table of Contents
Advertisement
3. CAMERA RE-ASSEMBLY
Make sure all wires are properly connected and
tightened into the terminal blocks as explained in
Section 2.
Step 3.1 -
Step 3.2 -
Step 3.3 -
Step 3.4 -
Check that the orange "O" ring
gasket in the rear half of the camera
housing has not been dislodged or
distorted.
Re-connect the camera wiring
harness plug back into its connector
on the Voltage Regulator Board.
Carefully slide the two halves of the
camera housing together, making
sure that the "O" ring gasket seats
properly and the camera harness
wires are not pinched.
Refer to Figure 3-1 on page 9.
Once the front and rear sections are
mated, insert and tighten the
housing screws into each side.
- 8 -
Advertisement
Table of Contents
