CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN WARNING: To reduce the risk of electric shock, do not remove cover or back. No user-serviceable parts inside. Refer servicing to quali¿ ed service personnel. The lightning flash with The exclamation point within arrow-head within a triangle a t r i a n g l e i s i n t e n d e d t o is in tend ed to tell the user...
To assure continued compliance, follow the attached installation instructions and use only shielded interface cables when connecting to computer or peripheral devices. Any changes or modi¿ cations not expressly approved by Panasonic Corp. of North America could void the user's authority to operate this device.
If the plug contains a removable fuse cover, you must ensure that it is re¿ tted when the fuse is replaced. If you lose the fuse cover the plug must not be used until a replacement cover is obtained. A replacement fuse cover can be purchased from your local Panasonic dealer. Do not cut off the mains plug.
• If water is spills onto the Display or foreign objects get inside it, a short-circuit may occur which could result in ¿ re or electric shock. If any foreign objects get inside the Display, please consult your local Panasonic dealer.
Page 6
If water or foreign objects get inside the Display, if the Display is dropped, or if the cabinet becomes damages, disconnect the power supply plug immediately. • A short circuit may occur, which could cause ¿ re. Contact your local Panasonic dealer for any repairs that need to be made.
Safety Precautions CAUTION When using the LCD Display Do not bring your hands, face or objects close to the ventilation holes of the Display. • Heated air comes out from the ventilation holes at the top of Display will be hot. Do not bring your hands or face, or objects which cannot withstand heat, close to this port, otherwise burns or deformation could result.
Safety Precautions Touch panel Carefully observe the following instructions as the display has an optical touch panel. Do not expose the display to direct sunlight or strong light source during use. • Otherwise malfunction may occur since the optical touch panel of the display uses infrared rays. After turning on the power of the display, do not touch the IR transmission part IR transmission part and the screen until any image is displayed.
Washer × 2 (see page 10) (see page 10) (see page 10) USB cable × 1 Power supply cord TH-80LFB70U TH-80LFB70E TH-80LFB70W Attention Store small parts in an appropriate manner, and keep them away from young children. Contents in the CD-ROM The contents below are included in the supplied CD-ROM.
Accessories Remote Control Batteries Requires two R6 batteries. 2. Insert batteries - note correct 3. Replace the cover. 1. Pull and hold the hook, then open polarity (+ and -). the battery cover. “R6 (UM3)” size Helpful Hint: For frequent remote control users, replace old batteries with Alkaline batteries for longer life.
Connections AC cord connection and ¿ xing, cable ¿ xing AC cord ¿ xing Unplug the AC cord Unplug the AC cord pressing the two knobs. Plug the AC cord into the display unit. Note: Plug the AC cord until it clicks. When disconnecting the AC cord, be Note: Make sure that the AC cord is locked on...
Connections Speaker connection Please use 8 /10 W speaker. Black Black Return the lever. While pressing the lever, insert the core wire. Video equipment connection SLOT: Terminal board (optional accessories) insert slot (see page 5) Note: The upper side slot is for terminal board with 2-slot width. The terminal board with 1-slot width does not function when installed in the upper side slot.
Power On / Off Connecting the AC cord plug to the Display. Connecting the plug to the Wall Outlet Notes: • Main plug types vary between countries. The power plug shown at right may, therefore, not be the type ¿ tted to your set. •...
Page 14
Power On / Off When ¿ rst switching on the unit Following screen will be displayed when the unit is turned on for the ¿ rst time. Use the remote control to make the settings. Pressing the buttons on the main unit or multi-touch operation will not work.
Basic Controls Power Indicator Main Unit The Power Indicator will light. • Power-OFF ..Indicator not illuminated (The unit will still consume some power as long as the power cord is still inserted into the wall outlet.) • Standby ..Red Orange (When “Slot power”...
Basic Controls Remote Control Transmitter OFF TIMER button The Display can be preset to switch to stand-by after a ¿ xed period. The setting changes to 30 ACTION button minutes, 60 minutes, 90 minutes and 0 minutes Press to make selections. (off timer cancelled) each time the button is pressed.
Speci¿ cations TH-80LFB70U TH-80LFB70E / TH-80LFB70W Power Source 110 - 127 V AC, 50/60 Hz 220 - 240 V AC, 50/60 Hz Power Consumption Power on 350 W 350 W Stand-by condition 0.5 W 0.5 W Power off condition 0.3 W 0.3 W...
Two Riverfront Plaza, Newark, New Jersey 07102-5490 Panasonic Professional Flat Panel Display Limited Warranty Panasonic Solutions Company. (referred to as “the antenna, inadequate signal pickup, maladjustment of Warrantor”) will repair this product and all included consumer controls, improper operation, power line surge,...
Page 24
Warranty Service purposes. Model Number Serial Number For TH-80LFB70U Panasonic System Communications Company of North America Unit of Panasonic Corporation of North America Executive Of¿ ce : Two Riverfront Plaza, Newark, New Jersey 07102-5490 Panasonic Canada Inc.