REV. DS-PAN1311/21USB PAGE Quick Start Guide 3 of 11 Evaluation Board (EVB) PAN1311/21 USB DATE 15.09.2011 2. INTRODUCTION This document should provide the minimum knowledge needed to establish a simple connection between two PAN1321ETU USB Evaluation Boards (EVB) using Infineon eBMU_SPP_Toolbox software.
REV. DS-PAN1311/21USB PAGE Quick Start Guide 4 of 11 Evaluation Board (EVB) PAN1311/21 USB DATE 15.09.2011 5. CONNECTION SETUP This chapter describes how to use the eBMU_SPP_Toolbox software in order to send simple data packages from one EVB to the other.
REV. DS-PAN1311/21USB PAGE Quick Start Guide 5 of 11 Evaluation Board (EVB) PAN1311/21 USB DATE 15.09.2011 5.2 PORT CONFIGURATION Please note that the eBMU Toolbox can handle only COM port numbers below 10. You can configure in the System Hardware settings in your operating system. The USB driver can be found in the installation folder.
REV. DS-PAN1311/21USB PAGE Quick Start Guide 6 of 11 Evaluation Board (EVB) PAN1311/21 USB DATE 15.09.2011 5.3 FIRMWARE HANDLING At the testing tab firmware can be downloaded (Download image) to the EVB and a number of changes can be made to it (Change BD-data) like assigning a unique BT address (e.g.
REV. DS-PAN1311/21USB PAGE Quick Start Guide 7 of 11 Evaluation Board (EVB) PAN1311/21 USB DATE 15.09.2011 5.4 COMMAND TAB NAVIGATION At the Commands tab are several commands listed for easy click-and-use. Note the colour coding identifying commands by their intended usage: Yellow: Settings and informational commands.
REV. DS-PAN1311/21USB PAGE Quick Start Guide 8 of 11 Evaluation Board (EVB) PAN1311/21 USB DATE 15.09.2011 5.5 CREATING A CONNECTION To send data from one EVB to the other one of them must be prepared for connection, while the other will request a connection. Follow these steps: 1.
REV. DS-PAN1311/21USB PAGE Quick Start Guide 9 of 11 Evaluation Board (EVB) PAN1311/21 USB DATE 15.09.2011 6. SCHEMATIC DESIGNED PANASONIC ELECTRONIC DEVICES EUROPE Erstellt GmbH...
REV. DS-PAN1311/21USB PAGE Quick Start Guide 10 of 11 Evaluation Board (EVB) PAN1311/21 USB DATE 15.09.2011 7. DOCUMENT INFORMATION Revision Date Modification / Remarks Version Datum Änderungen / Bemerkungen 18.04.2011 Initial version 15.09.2011 Updated documentation information in chapter 2.1 Table 3 : Document version...
9. LIFE SUPPORT POLICY This Panasonic product is not designed for use in life support appliances, devices, or systems where malfunction can reasonably be expected to result in a significant personal injury to the user, or as a critical component in any life support device or system whose failure to perform can be reasonably expected to cause the failure of the life support device or system, or to affect its safety or effectiveness.