Troubleshooting; Error Messages - Husqvarna DXR300 Operator's Manual

Error messages

There are two types of error messages that can appear on the display:
• Service messages - These messages do not represent any direct danger for the operator or the machine.
• Warnings - These warn of faults or safety defects that can cause mechanical damage.
All error messages that have been acknowledged remain as small yellow red warning triangles in the field for service and can be
accessed by bringing up the service menu and selecting 'Warnings". The messages are listed in order of priority, highest priority
first.
When a fault that has in some way restricted the machine's functions ceases, a message appears on the display. This message
must be acknowledged for the machine to return to full functionality.
Service messages
Message on the display
Oil filter need to be changed
Low hydraulic oil level
Low battery
Left joystick button on left joystick
activated during power up. Button has
been disabled.
Right joystick button on left joystick
activated during power up. Button has
been disabled.
Left joystick button on right joystick
activated during power up. Button has
been disabled.
Right joystick button on right joystick
activated during power up. Button has
been disabled.
Up/Down movement on left joystick
activated during power up. Up/Down
movement has been disabled.
Left/Right movement on left joystick
activated during power up. Left/Right
movement has been disabled.
Up/Down movement on right joystick
activated during power up. Up/Down
movement has been disabled.
Left/Right movement on right joystick
activated during power up. Left/Right
movement has been disabled.
Connection to terminal radio failed.
Please check battery level and restart
terminal.
Cable connection established between
terminal and machine but no control
modules found. Please check cable and
control modules.
Radio connection established between
remote control and machine but no
control modules found. Please check
control modules and CAN connection in
machine.

TROUBLESHOOTING

Indication on the
machine
Flashes 3 times with the
work lighting.
No indication on machine.
Cause
The oil filter must be
replaced.
Oil level is low.
Low battery level in
terminal.
Joystick activated during
terminal start up.
The terminal can not
communicate with the
terminal radio
The terminal can connect
to the machine but not to
PLC modules.
The terminal can connect
to radio in the machine but
not to PLC modules.
Possible action
Replace the oil filter.
Fill in more oil.
Change battery or connect
orange cable.
Check joystick value in test
menu (terminal
diagnostics). Restart
terminal.
Change battery, check
cables to terminal radio.
Check fuses to the PLC
moduels, check supply and
CAN cables to the
modules.
– 47
English