Filling With Water; Setting Temperature; Steam Ironing; Description - Kenwood Discovery duo ST60A Instructions Manual

This appliance conforms to EC
directive 2004/108/EC on
Electromagnetic Compatibility and
EC regulation no. 1935/2004 of
27/10/2004 on materials intended
for contact with food.
before using for the first time
1 Remove all packaging and any
stickers or labels, (including those on
the soleplate).
Note, if used with a travel adaptor
please note any warnings given by
the adaptor supplier.
2 Test-iron an old cloth to make sure
the soleplate and water tank are
clean.
Repeat step 2 after periods of
prolonged storage.
know your Kenwood iron
steam knob
water tank
water tank release lever
handle release button
folding handle
temperature control
button groove
soleplate
steam vents
dual voltage selector
heat resistant slipper
temperature indicator light
cable tidy

using your iron

filling with water

1 Unplug.
2 Press the water tank release lever
and lift off the water tank
3 Unclip the rubber bung and hold out
of the way.
4 Fill the tank with water, then refit the
rubber bung.
5 Clip the water tank back into position
on the iron.
fter ironing, unplug, remove the
water tank and empty out any
remaining water.
choosing the right
temperature
Follow the clothes label advice.
Match the dots on the label to the
dots on the temperature control. If
there's no label, here's a guide on
which temperature to choose:
cotton, linen
wool, silk
synthetics (eg acrylic, nylon,
polyester, viscose)
hints
Start with clothes needing the lowest
temperature, then work upwards.
(This lowers the risk of burning
something because an iron switched
from 'hot' to 'cool' takes time to cool
down.)
For mixed fibres, eg cotton and
polyester, use the lowest suitable
temperature.
If in doubt, start with a low
temperature on a part that won't be
seen (eg a shirt tail).
setting the temperature
1 Stand the iron upright.
2 Turn the temperature control to the
temperature you want
When the iron reaches the selected
temperature, the indicator light will go
out. (During ironing, the light will go
on and off as your iron maintains the
right temperature.)

steam ironing

1 Fill with water.
2 Turn the temperature control to
3 Plug in. When the temperature light
goes out press the steam knob in
.
short bursts. Release the knob to
stop the steam.
If the steam knob is pressed before
the iron reaches the correct
temperature, water will leak from the
vents in the soleplate.
Prolonged use of the steam knob
may also cause water to drip from
the vents in the soleplate. If this
occurs wait for the temperature
indicator light to go out before
continuing.
4
.
.