Page 1
INSTRUCTION MANUAL Hammer Drill HP1630 HP1631 008892 DOUBLE INSULATION WARNING: For your personal safety, READ and UNDERSTAND before using. SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
AC supply. They Authorized Representative in Europe: are double-insulated in accordance with European Makita International Europe Ltd. Standard and can, therefore, also be used from sockets Michigan Drive, Tongwell, Milton Keynes, Bucks MK15 without earth wire.
Page 3
GEA005-2 under the influence of drugs, alcohol or medication. A moment of inattention while General Power Tool Safety operating power tools may result in serious Warnings personal injury. Use personal protective equipment. Always WARNING Read all safety warnings and all wear eye protection.
power tool's operation. If damaged, have the WARNING: power tool repaired before use. Many accidents are caused by poorly maintained power tools. MISUSE or failure to follow the safety rules stated in 22. Keep cutting tools sharp and clean. Properly this instruction manual may cause serious personal maintained cutting tools with sharp cutting edges injury.
Page 5
Installing or removing drill bit If the switch trigger can not be depressed, check to • For Model HP1630 see that the reversing switch is fully set to position (A side) or (B side).
Depth gauge prevent it from slipping away from the hole. Do not apply more pressure when the hole becomes 1. Depth gauge clogged with chips or particles. Instead, run the tool at 2. Side grip an idle, then remove the bit partially from the hole. By 3.
Only use accessory or attachment for its stated purpose. If you need any assistance for more details regarding these accessories, ask your local Makita Service Center. Tungsten-carbide tipped hammer bit • Blow-out bulb • Safety goggles •...
Page 8
Makita Corporation Anjo, Aichi, Japan 884816A225...