Page 1
HUAWEI FT2260 Home Phone Connect Quick Start Introduction Top View Note: The figures are only for your reference, the actual shape and color of the product may differ slightly. Power on/off switch Antenna port...
Telephone port 1 Signal strength indicators Telephone port 2 Battery indicator USB port* Power indicator DC 12V power port Voice mail indicator * Note: Never place a USB-based device into the USB port of the Home Phone Connect under any circumstances.
Installation Installing the Battery Note: If the ambient temperature exceeds the temperature allowed for charging, the device stops charging the battery. If connected to the power adapter, the device automatically charges the battery and stops charging when the battery is fully charged. ...
Installing the Antenna Power the device off. Connect the indoor antenna to the antenna port as shown in the following figure, and screw on the antenna until it is securely connected. Installing the Power Adapter Under normal operation, the Home Phone Connect is powered from an A.C. power outlet using the power adapter that is included with the device.
Connecting the Device to a Telephone The device provides two telephone ports. The ports provide connection to a single telephone number assigned to the device by your service provider. Unplug your telephone from your wall's telephone jack. Do not plug Home Phone Connect into your telephone wall jack, this configuration is not supported unless you have taken steps to disconnect the landline wires coming into your home.
Powering on the Device Press the button to power on the device. When the device is on, the power indicator will be blue. Note: Press and hold the button for 1 second to power off the device. Activating the Device If your device has not yet been activated, please follow the steps below: Dial * 2 2 8 from a telephone that is connected to the Home Phone Connect to activate the device.
Understanding the Indicators The following table describes your device’s status at any given time. Icon Indicator Status Blinking Blue New Message Voice mail Blue Full Charge Blinking Blue Partial Charge Battery Blinking Red Low Charge Both Blue Strong One Blue Moderate Signal Strength One Blinking Blue...
Call Forwarding The device allows you to forward calls to another phone number, including your mobile phone or office number. Your Home Phone Connect will not ring until you deactivate the service. Airtime applies to forwarded calls even if you send the call to wire line telephones. To Activate Call Forwarding: Dial * 7 2.
Page 9
911 Calls Since the device is designed for an indoor environment, please be prepared to provide your location inside the premises to public service personnel. The GPS chipset embedded in this device will work best if the device is located near a window or other opening. ...