Table of Contents
Advertisement
10
en | Product Description
4.3
Cancel / Action button (S button)
4.3.1
Cancel emergency call
If you have pressed the emergency call button by mistake, you
can cancel the call with the Action button during the pre-alarm
time. Press the Action button until the unit announces "stop".
Calls cannot be cancelled after the pre-alarm time.
4.3.2
Take the first incoming call
If your Carephone 62 is delivered to you unprogrammed, this
special function allows you to accept the first incoming call.
If the first incoming call is from your monitoring centre, the
operator can start a remote programming session. See
Section Remote programming from a monitoring centre, page 21.
NOTICE!
This action can be performed at the initial start of the
Carephone. See Section 4.6 Device acknowledgments, page 12.
4.3.3
Action button: service call
You can program the Action button to act as a service button. If
you press the button and hold it for at least 2 seconds, the unit
dials a call number that has been programmed for the service
call and you hear the announcement "service call".
4.3.4
Action button: direct call
You can program the Action button to make a direct call. When
the Action button is pressed, the Carephone 62 makes one
single call to an analog telephone destination. In case of a call
sent by a direct call, the alarm can also be cancelled after the
pre-alarm. A direct call is not possible with an IP connection.
F.01U.141.162 | V6 | 2015.04
Press 3 times the Action button within three seconds.
User Manual
Carephone 62
TeleAlarm
Advertisement
Table of Contents
