Back Cover
Remove all the screws marked with an arrow(
from the back of the Receiver.
•
3 screws at the top edge of the Receiver.
•
1 screw at each lower corner of the Receiver.
•
1 screw by the A/V jacks.
•
1 screw by the AC cable opening cover.
•
1 screw closest to the antenna terminal.
•
1 screw by the Flyback.
Figure 5. Back Cover Screw Location
A-Board - Main Chassis
The board is secured in place by the guide rails and by
the DVD bracket.
1. The A-board is mounted on rails that are attached
to the DVD bracket. To remove the rails, DVD
bracket and A-Board press on the tabs located at
the bottom of the cabinet and pull forward.
2. Press on the tabs located on the DVD bracket to
release the A-Board from the hardware.
Note:
Some tie-wraps that secure the wire dressings
may need to be unfastened for chassis
removal.
IMPORTANT NOTE:
Reuse
bolts, connectors, etc.) upon
reassembling the Receiver.
珍惜眼前人 搜集整理
Disassembly for Service
hardware
(screws,
C-Board - CRT Output
Socket plugs onto the CRT neck.
)
Figure 6. C-Board Assembly
G-Board - Video Input (Front)
Fastened to the front panel. Position bottom of
board on back of front panel and secure with
1 screw.
Figure 7. G-Board Assembly
JJ-Board - A/V Switch, A/V Decoder
Plugs perpendicularly into 4 connectors on the
A-Board.
Figure 8. JJ-Board Assembly
- 10 -
QQ:362399998
QQ群:12919880