SERVICE MANUAL FL0911008V1.1 Order No. Front Load Washing Machine MODEL: HW50-1010W HW50-1010S WARNING This service information is designed for experienced repair technicians only and is not designed for use by the general public. It does not contain warnings or cautions to advise non-technical individuals of potential dangers in attempting to service a product. Products powered by electricity should be serviced or repaired only by experienced professional technicians.
SERVICE MANUL 4 HW50-1010W/HW50-1010S Chapter 1 General Information 1-1. General Guidelines When servicing,observe the original lead dress.If a short circuit is found, replace all parts which are overheated or damaged by the short circuit.After servicing ,see to it that all the protective devices such as insulation barriers ,insulation papers shields are properly installed .Confirm that the screws,parts and wiring...
SERVICE MANUL 5 HW50-1010W/HW50-1010S Chapter 2 Product Feature 2-1. Features (1). 300mm diameter porthole, door may be open at a 180 degrees. Facilitate view of wash process, facilitate unloading and easy to use with large port. (2). Class A energy-saving...
Page 6
SERVICE MANUL 6 HW50-1010W/HW50-1010S Description of appliance Washing machine Type of appliance(FS = standing, BI = built-in) Supplier own brand Haier Supplier bar code(Europe) Commercial Brand / Model Commercial bar code Key-Features Energy efficiency class Washing performance class Spin efficiency class Programs n°...
SERVICE MANUL 17 HW50-1010W/HW50-1010S 8-2. Adjusting the washing machine 8-4. Joining the Inlet Hose to the Washing Machine 8-5. Drainage Hose Front Load Washing Machine...
Page 18
SERVICE MANUL 18 HW50-1010W/HW50-1010S Front Load Washing Machine...
SERVICE MANUL 21 HW50-1010W/HW50-1010S 9-2. Self check Press “Strong Wash” button, and plug in, then the WM will be on self-inspection mode, all the indication light will be on. Press start/pause button starts the Testing Program. 1.Door lock switch testing, if the door is unlooked, Failure alarm 1.
SERVICE MANUL 22 HW50-1010W/HW50-1010S light of cotton pre-wash on 750/760 light of cotton & flax 90 on 650/660 washing program indication Corresponding spin light speed X.3 The model can only be selected from high spin speed to lower spin speed, once saved, it can’t reverse adjust, however, when the Temperature sensor is off, it can.
SERVICE MANUL 23 HW50-1010W/HW50-1010S Troubleshooting: Cut off power and water level pressure switch wire connection, measure the resistance of 11 and14 pin, Check if water is emptied is it infinite? If not, it is water level pressure switch failure and replaces it. If it is, then repair and check PCB and wire as followed.
Page 24
SERVICE MANUL 24 HW50-1010W/HW50-1010S Error 4 The start indicator lighted on 0.2s andoff 0.2s for 4 times,repeate 4s later . Error message:The heater may be broken Troubleshooting: Check if overload laundry. Reduce the laundry Heater element must Cut off power, check the resistance of...
Page 25
SERVICE MANUL 25 HW50-1010W/HW50-1010S Observe height of drain pipe Draw out the dispenser and check if not reach 80 cm. If water is entering water level pressure switch and the hose is leaking gas Turn on power, and set pre-wash mode, then start.
SERVICE MANUL 26 HW50-1010W/HW50-1010S Error 8 The start indicator lighted on 0.2s andoff 0.2s for 8 times,repeate 4s later . Error message. Water level exceeds protection value. Troubleshooting: Clean water switch hose and air Check if water switch hose and air collector...
SERVICE MANUL 27 HW50-1010W/HW50-1010S 10-2-2. No water inletting Troubleshooting: Is the tap shut off or the water pressure Open tap or wait for normal water too low? pressure Check if water is leaking from washer connection, especially between inlet pipe and tap.
SERVICE MANUL 28 HW50-1010W/HW50-1010S 10-2-3. No draining roubleshooting: Adjust the height of drainpipe to Is the height of drain pipe too high? 80-100 cm Turn filter anticlockwise , open and check if filter is jammed Clean and tighten filter clockwise.
SERVICE MANUL 29 HW50-1010W/HW50-1010S 10-2-5. Water leaking Troubleshooting: Check if water is leaking from the inlet pipe Readjust it or the tap Is drain pipe broken? Replace drainpipe Check if there is foreign material nipped Remove clothes between cushion of sight window and...