Do not disassemble the unit. If a problem occurs within the unit please contact the service center. Install the OptiCAM-IR as follows: 1. Attach the mounting bracket (Figure 1) to the camera (Figure 2). Attach the mounting bracket to the hole below or over the camera tightly.
Page 6
OptiCAM-IR Installation and Setup Guide Figure 1. Mounting Bracket Figure 2. Camera Figure 3. Sun Visor 2. Install the camera on the wall or ceiling. 3. Connect the video cable of the camera to the monitor The power supply should have a regulated, 12VDC, 500mA output. The power should be connected after the camera has been installed.
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • Opicoax-1 (Figure 4) is a single camera adapter that allows any standard BNC camera such as the OptiCAM-IR to be converted to an RJ-45 connection for CAT-5 cabling to an Optiflex Video Controller.
Limited Warranty or otherwise if the product(s) is altered or improperly repaired or serviced by anyone other than Honeywell factory service. Connection of any device(s) to a communicating bus of a Honeywell security system (e.g., keypad bus, polling loop) other than those manufactured or approved by Honeywell shall void this warranty. For warranty service, return product(s) transportation prepaid, to Honeywell Factory Service, 165 Eileen Way, Syosset, New York 11791.
Page 16
165 Eileen Way, Syosset, NY 11791 Copyright 2005 Honeywell International Inc. www.honeywell.com/security ÊK6185?Š K6185 3/05 Rev. A...