Starting The Hybrid Ip-Pbx - Panasonic KX-TDA100 Getting Started

3.1 Starting the Hybrid IP-PBX

3.1 Starting the Hybrid IP-PBX
CAUTION
• SD Memory Card must be inserted in the SD Memory Card slot of the MPR card before start
up.
• Before touching the System Initialise Switch, discharge static electricity by touching ground
or wearing an earthing strap.
• Once you have started the Hybrid IP-PBX and if you unplug the Hybrid IP-PBX, do not
perform the following procedures to start the Hybrid IP-PBX again. Otherwise, your
programmed data will be cleared.
• The Hybrid IP-PBX will continue to be powered even if the power switch is turned "OFF".
• The power supply cord is used as the main disconnect device. Ensure that the AC
outlet is located near the equipment and is easily accessible.
1.
Slide the System Initialise Switch to the "SYSTEM INITIALIZE" position.
Power
Supply Unit
To AC
Outlet
2.
Plug the AC power cord into the Hybrid IP-PBX and an AC outlet, and turn on the Hybrid IP-PBX.
The RUN indicator will flash.
3.
While the RUN indicator is flashing, slide the System Initialise Switch back to the "NORMAL"
position. Depending on the configuration, initialisation takes about 1 min to 3 min. If successfully
executed, the RUN indicator will stop flashing and stay lit.
All data will be cleared and the Hybrid IP-PBX will be initialised to the default values. The DPTs should
show the time as 01:00.
Note
Use only the AC power cord included with the Hybrid IP-PBX for the PSU.
18 Getting Started
RUN Indicator
System Initialise Switch
SYSTEM
INITIALIZE
NORMAL