Bosch Carephone 62 User Manual page 32

32 en | Programming
Easy wireless transmitter registering with top-cover installed
–
–
–
–
–
–
The code number of the wireless transmitter is registered in
Selection 91 (erasing the previous code number).
Enter easy unit ID programming
–
–
–
–
Remote programming (incoming)
–
The device acknowledges by announcing "Setup activated" and
enters the incoming remote programming mode.
Set date and time with the keyboard
–
–
–
–
–
–
F.01U.141.162 | V5 | 2014.09
Press buttons <Yellow> <Green> together for at least two
seconds.
The unit waits for a wireless signal.
Press the button of the wireless transmitter.
The unit acknowledges with a beep.
Press the button of the same transmitter to confirm.
The unit acknowledges with two beeps.
Press P, 3 and 0 together for at least two seconds.
The unit goes directly to Programming Step 30.
Type the unit ID (device number) with numeric keys, the
unit ID can be up to 12 digits long.
Press C to confirm.
Press buttons <Yellow> <Green> <Grey> together for at
least two seconds.
Press P and B together for at least 2 seconds.
The four indicator lamps light up bright.
The Carephone 62 announces "setup B", then announces
the current date and time value in the format DD MM YYYY
HH MM as a list of digits.
Enter the value of the date and time in the above format,
using keys 0 to 9. As soon as 12 digits are entered, the
input is evaluated to determine if the date & time are valid.
There is no need to confirm with C.
The Carephone 62 plays a sound when the input is valid or
announces "failure" if it is incorrect. If it is incorrect, type
it again.
Exit the date and time programming mode by pressing *.
User Manual
Carephone 62
Bosch Security Systems