General/System Set-Up; Service - Kenwood TK-8180 Service Manual

SERVICE

This radio is designed for easy servicing. Refer to the
schematic diagrams, printed circuit board views, and align-
ment procedures contained in this manual.
NOTE
• If you do not intend to use the speaker 3.5-mm jack and
the D-sub 25-pin connector, fit the supplied speaker-jack
cap and D-sub cap to stop dust and sand from getting in.
• If the transceiver is turned ON or OFF when the power-on/
off status message is enabled, the transceiver sends the
status.
SYSTEM SET-UP
License and frequency allocated by FCC
Choose the type of transceiver
GENERAL / SYSTEM SET-UP
Merchandise received
YES
Are you using
the remote kit?
NO
Are you using
YES
the ignition sense cable?
NO
See page 4.
A personal computer (IBM PC or compatible), programming
Transceiver programming
interface (KPG-46), and programming software (KPG-89D)
are required for programming.
Are you using
YES
the radio interface cable?
NO
Modem GPS receiver
Modem GPS controller
Are you using
YES
the public address?
NO
Are you using YES
the voice guide & storage
unit?
NO
Are you using YES
the external speaker?
NO
Are you using
YES
the keypad microphone?
NO
Supplied microphone
Delivery
Antenna
connector
Frequency range RF power
30W
450~520MHz
(490~520MHz : 25W)
See page 9.
KRK-10
(Option)
See page 7.
KCT-46
(Option)
See page 7.
KCT-40
(Option)
KCT-36 Extension cable (Option)
KGP-2A KDS-100
or
Mobile data terminal
or
(Option)
KGP-2B
(Option)
See page 8.
KAP-2
(Option)
See page 10.
VGS-1
(Option)
KES-3 or KES-5 External speaker
(Option)
KMC-32 or KMC-36
(Option)
Desk top microphone KMC-9C
TK-8180
Speaker D-sub
jack cap cap
Ignition
sense cable
Power input
connector
Type
K
3