14.1.6 +CGDATA Enter data state
Command
execute
+CGDATA=<L2P>[,<cid>]
test
Optional. 07.60 section 10.2.6. Causes the MT to perform whatever actions are necessary to
establish communication between the TE and the network using one or more GPRS PDP
types. The Nokia D211 supports only <L2P>="PPP". Valid <cid> values are 1 and 2 for
current GSM products. If the user, however, uses a non-existent <cid> value, even if within
valid range, DCE shall issue an ERROR result code to such an attempt. See +CGDCONT.
Supported value of <cid>: 1. NOTE: GPRS Phase 1 does not support mobile-originated
context modification.
15. MISCELLANEOUS COMMANDS
15.1 V.25TER
15.1.1 A/ Repeat last command line
Mandatory. V.25ter section 5.2.4. As first chars in command line replacing normal AT. Also
lowercase (a/) accepted.
15.2 NMP SPECIFIC
15.2.1 S47 Force fax class 2/2.0 error correction mode
Command
Response
set
S47=<n>
read
S47?
<n>
Recommended when fax ECM is implemented. Used to force ECM on, as most fax software
does not function so as to enable it. 0=disabled, 1=enabled with 64 byte frames, 2=enabled
with 256 byte frames.
possible result codes
CONNECT
NO CARRIER
+CGDATA: ("PPP")
<n> values
0..2 (default 0)
000..002
Description
Enter data state
Data state cannot be
entered
98/113