Installation; Module Installation - Bosch ICP-AMAX4-P1 Installation Manual

AMAX panel 4000 / AMAX panel 4000
EN
6

Installation

This chapter specifies installation and system power up of the AMAX panel.
During installation and wiring, the AMAX panel power source must be switched-off to prevent
equipment damage.
–
–
The User has to disconnect all Telecommunication Network Connectors before unplugging the
power adaptor.
6.1

Module Installation

The enclosure contains only PCBs and transformers of the fixed AMAX panel, not other
hardware for installation.
1.
2.
3.
4.
5.
6.
Notice!
Please choose appropriate positioning screw kit when you have to install in a non-load
bearing wall.
1
Figure 6.1: Enclosure / with mounting plate
Bosch Sicherheitssysteme GmbH
To switch off the power source, an easy accessible circuit breaker must be available
The system / product must be connected to a socket-outlet with a protective earthing
contact
Open the knockout holes for wiring in the module.
Position two upper mounting holes on the installation wall with the module.
Pre-install screws on the mounting holes (provided by the installer).
Mount the screws on the module.
Fasten the screws.
Fix the two lower mounting holes with screws.
Enclosure - Standard
2
1
Installation Guide
Installation | en
4
3
E N √ E N √
Enclosure with mounting plate
2014.4 | 01 | F.01U.267.112
23
2