Table of Contents
Advertisement
I Disasembly
1 )
2 )
3 )
.u)
6)
8)
e)
4 )
Undo screw O to remove the bonnet case.
Remove screw @ to dismount the stay.
For the removal of the bottom plate, re-
move screw (O ot the bottom of the set.
This allows the soldering on the composite
assembly (B) to come into view.
Removing rivet @ and screw @ on the
rear panel causes the P.C.B. holder to be un-
fastened, enabling DOLBYINR
assembly
to be detachable.
The complex assembly (B) can be dis-
mounted by removing screw @
Removing scre\ry (D
"t
well as hook @ on
PB support permits the power supply as-
sembly to be dismounted. Then, the power
knob assembly can be removed from the
po\Mer supply assembly.
When the power supply assembly is remov-
ed, the transistor assembly comes into view.
Remove screws to dismount the transistor
assembly.
Undo screïv G) ott its lower portion to re-
move the transformer.
For the removal of door panels A and B,
slide the panels upward with the doors kept
open.
10) To remove the front panel base, undo screw
L
and slightly lower the panel stayhook
(D(upper four portions) and hookQ(lower
two portions) using a flat screwdriver, etc.
11) the tape counter is removed by removing
screw lE .
L2\ The panel stay is removed by removing
screw O
.
The display assembly is removed by remov-
ing the panel stay hook (without having to
remove the front panel assembly).
The push and PC knobs are detachable
from the display assembly when the latter
is removed.
The eject knob is removed by removing the
hook on the back of the panel staY.
Remove screw @
to dismount the casset-
tE mechanism unit (the removal of the
porver knob assembly enables the mecha-
nism unit to be dismounted without requir-
ing the front panel assembly to be re-
moved).
1 3 )
14)
1 5 )
1 6 )
7',)
Advertisement
Table of Contents
