Pulse Speed Selection - Panasonic KX-TD1232 Program Manual

General Programming

[403] Pulse Speed Selection

Description
An outside line set for pulse or call blocking mode in program [402] Dial Mode Selection
can have two pulse rates, 10 pps (low) and 20 pps (high). This program sets the pulse speed for
each outside line set to pulse or call blocking mode.
Selection
• Outside line (CO) number:
KX-TD816 — 01 through 08,
KX-TD1232 —01 through 24,
( =all outside lines)
• 10 pps / 20 pps
Default
All outside lines — 10 pps
Programming
1.
Enter 403.
Display: 403 PULSE SPEED
2. Press NEXT.
Display: CO Line NO?
3. Enter an outside line number.
To enter outside line number 01, you can also press NEXT.
Display example: CO01:10pps
4.
Keep pressing SELECT until the desired selection is displayed.
5.
Press STORE.
6. To program another outside line, press NEXT or PREV, or SELECT and the desired
outside line number.
7.
Repeat steps 4 through 6.
8.
Press END.
Conditions
• For the KX-TD1232, outside lines 01 through 12 are for the Master System and outside
lines 13 through 24 are for the Slave, if available.
• To assign all outside lines to one selection, press the
shows the contents programmed for outside line 01.
• The pulse speed required is determined by the outside or PBX line.
174
key in step 3. In this case, the display
Programming Guide