Cleaning And Care; Casing - Miele DA 5960 W Operating And Installation Instructions

,
Before any cleaning or
maintenance work is carried out,
disconnect the rangehood from the
mains supply. Ensure that
– it is switched off at the wall
socket and the plug removed,
or
– the mains fuse is withdrawn, or
– the screw-out fuse is removed
(in countries where this is
applicable).
,
Exercise caution when changing
halogen lamps. They get very hot
during use, and remain hot for some
time after being switched off. Do not
touch the surface directly when
changing a lamp, as grease particles
from your fingers will adhere to the
surface and damage it.
The halogen lamps can also be
damaged if water is used to clean
them.
Wait several minutes after switching
off before beginning cleaning.

Casing

General notes
The surfaces and controls are
susceptible to scratches and
abrasion. Please observe the
following cleaning instructions.
^ All external surfaces and controls can
be cleaned using warm water with a
small amount of washing-up liquid
applied with a well wrung-out soft
sponge or cloth.

Cleaning and care

^ Wipe the surfaces dry using a soft
cloth.
Do not use too much water when
cleaning the controls. Water could
penetrate into the electronics and
cause damage.
Do not use:
– cleaning agents containing soda,
acids, chlorides or solvents,
– abrasive cleaning agents, e.g.
powder cleaners or cream cleaners
and abrasive sponges, as well as pot
scourers or sponges which have
been used previously with abrasive
cleaning agents. These will damage
the surface material.
Important for appliances with
stainless steel casing
(This infomation does not apply to the
controls).
Stainless steel surfaces can be cleaned
with a proprietary non-abrasive
cleaning agent designed specifically
for use on stainless steel.
A specially designed stainless steel
detergent which prevents resoiling can
be purchased from the Miele Spare
Parts Department. Apply sparingly with
a soft cloth following the instructions on
the packaging.
15