Compatible Equipment; Compatible Network Cameras; Connecting A Ups - JVC VR-N900U Instructions Manual

Compatible Equipment

Others

Compatible Network Cameras

Function
JPG PTZ
Network Camera
JVC
●
VN-C20
JVC
● ●
VN-C655
JVC
● ●
VN-C625
JVC
● ●
VN-E4
JVC
●
VN-C215
●
AXIS 206
●
AXIS 207
AXIS 211 ●
●
AXIS 216
AXIS 225 ●
Verint
●
S1700
Verint
●
S1704
Verint
●
S1708
Verint
S1900
Verint
S2700E
PTZ VMD
Audio MPG4
Joystick Event
●
●
● ●
●
● ●
● ●
●
● ●
● ●
● ●
●
●

Connecting a UPS

Connecting an uninterruptible power supply (UPS) to the
hard disk will protect it from damage by automatically
powering down all operations prior to switching off the power
supply in the event of a power failure.
1
Connect the UPS communication cable to the
[SERIAL] port on the rear panel.
2
Connect the VR-N900U power cable to the UPS
power output connector.
3
Switch on the power to the UPS, then switch
on the power to the VR-N900U.
CAUTION
●
• Consult your nearest JVC dealer for details on the UPS
●
that can be used.
●
●
• Make sure the UPS communication cable is connected
before switching on the power to the VR-N900U.
• Do not disconnect the communication cable when
operations are being carried out.
• If a power failure occurs during archiving or formatting of
the hard disk, operation of the equipment may be disabled
even if it is connected to the UPS.
• The recorded images may not play back properly if they
were not archived (
☞
Page 56) before the power failure.
73